Maytag Dishwasher Error Code 10-1

Error code 10-1 on a Maytag dishwasher indicates an electrical problem in the dispenser circuit. The control board is detecting an open circuit condition when it attempts to activate the dispenser solenoid. This can be caused by a loose wiring connection, a failed dispenser solenoid, or a blown fuse on the control board protecting the dispenser circuit.

You should not continue running the dishwasher while the 10-1 code is active. The dispenser circuit has a detected electrical fault, meaning detergent may not be dispensed properly and the underlying wiring or component issue could worsen. Disconnect power and have the fault diagnosed before resuming use.

Resetting the dishwasher by disconnecting power may temporarily clear the displayed code, but the fault will return if the underlying electrical problem has not been corrected. The 10-1 code is triggered by a real circuit condition, such as an open solenoid or broken connection, that must be physically repaired before the code will stay cleared.

A knowledgeable DIYer can perform the initial diagnostic steps after disconnecting power to the dishwasher. Checking wiring connections for looseness and testing the dispenser solenoid for continuity with a multimeter are accessible tasks. However, if the fault traces back to the control board fuse or the drive circuit on the board itself, repair becomes more complex and may be better suited for a qualified technician.

Repair costs vary depending on the root cause. Reseating a loose connector costs nothing beyond your time. A replacement dispenser solenoid assembly typically ranges from $20 to $60 in parts. A new control board can range from $100 to $250 or more in parts alone, with additional labor costs if a technician performs the repair.