Maytag Dishwasher Error Code 00

Code 00 on a Maytag dishwasher marks the beginning of the error display mode. When 00 is the only code shown, it means the control board found no stored fault codes. This is a confirmation that the dishwasher is operating normally and no errors have been detected.

Yes, code 00 indicates a clean bill of health from the control board. There are no detected faults affecting safety or performance. You can use the dishwasher normally without any concern.

Code 00 requires no repair, so there is no associated repair cost. If you entered diagnostic mode in response to a performance issue but received only code 00, a service technician visit to investigate further might range from around $75 to $150 for a diagnostic call, depending on your location and provider.

No repairs are needed when code 00 is the only code displayed. The dishwasher has passed its internal diagnostic check and all monitored systems are functioning properly. Simply exit the diagnostic mode and resume normal use.

Code 00 does not need to be cleared because it is not an error. Exiting the diagnostic mode returns the dishwasher to its normal operating state. A power reset is unnecessary for this code but will not cause any harm if performed.