Model reference
Maytag DW730
Dishwasher
2 documents17 error codes13 service modes
Available documentation
Service Manual
- Service Manual Supplement - 16006946-0146 pg
- Jenn-Air Dishwasher Service Manual180 pg
MyPros+ Max
Diagnose your Maytag DW730.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (17)
CodeMeaning
00Beginning of error display mode; no errors detected by the controller.1F0Wash arm sensor error; five cycles in a row concluded with a blocked wash arm…1F1Conductivity fault; a bad conductivity sensor reading has occurred.1F2High limit thermostat tripped; a temperature above 155°F (or 185°F per…1F3Communication problem; control and sensor pack communications not operating…1F4Cold water problem; water below 90°F is being detected at the temperature…1F5Current sensor bad; the controller has sensed that the current sensor is not…F0Control board error; an error with the controller has been sensed.F1Motor fault; motor current not changing/not detected.F2Heater fault; heater current not changing/not detected.F3High current error; electrical current within the machine is higher than normal.F4Detergent fault; no conductivity change detected in the main wash for 10 cycles.F5Rinse aid fault; an error with the rinse aid dispensing has been sensed.F7Turbidity sensor fault; a bad turbidity sensor reading has occurred.F8Wash arm fault; an error with the wash arm rotation system has been sensed.F9Thermistor fault; a bad temperature sensor reading has occurred.PFPower failure occurred during a cycle; options selected before the failure will…Service modes (13)
- Automatic Function Test (DW961UQ)Press initial sequence
- Circuit Board Test (DW960/DW980 - Original)Press initial sequence
- Circuit Board Test (DW960/DW980 - Series A5 and later)Press initial sequence
- Circuit Board Test (DW961UQ)Press initial sequence
- Dishwasher Function Test (DW960/DW980)Press initial sequence
- Error Fault Code Display (DW1000)Press initial sequence
- Functional Test Mode (DW1000)Press initial sequence
- Intelli-Bump (DW1000 Sensor Start adjustment)Press LOCK, CANCEL, CANCEL, SANI SCRUB
- Manual Function Test (DW960/DW980 - Series A5 and later)Press initial sequence
- Manual Test (DW961UQ)Press initial sequence
- Manual Test Mode (DW1000)Press initial sequence
- Rapid Time Down Test (DW960/DW980)No initial sequence required
- Rapid Time-Down Mode (DW961UQ)Select a cycle, then within one minute press the selected cycle key again and the AccuTemp key…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Maytag dishwasher models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass