Samsung Dryer Error Code FC

FC on a Samsung dryer means the electronic control board has detected a power source frequency that is outside the acceptable range for the appliance. It is a power supply fault rather than a problem with a mechanical component inside the dryer. The control board monitors incoming AC frequency and triggers this code when the reading is invalid. Restarting the dryer is the recommended first step.

Start by performing a power cycle to see if the code clears on its own. If it persists, verify that the dryer is connected to the correct power supply for its rated frequency. Check the outlet, circuit wiring, and terminal block connections for damage or looseness. If the power supply checks out and the code remains, contact a Samsung customer service center for professional service.

Repair costs vary depending on the root cause. If the issue is a simple power supply anomaly that clears with a reset, there is no cost. If a wiring or outlet repair is needed, electrician fees typically range from $75 to $200 or more depending on the work required. If the electronic control board requires replacement, parts and labor costs generally range from $150 to $350, varying by service provider and part availability.

A reset will clear the FC code if it was caused by a temporary power fluctuation. To reset, cancel the current cycle and disconnect the dryer from power for at least a minute before restarting. If the FC code returns after the reset, the underlying cause, such as a frequency mismatch or a faulty control board, has not been resolved and will need further diagnosis.

The dryer will not operate normally while the FC code is active, as the control board has detected a power supply problem. Continuing to attempt to run the dryer without resolving the underlying cause is not recommended. Have the power supply and dryer inspected before resuming use to avoid potential electrical issues.