Thermador Range Error Code Er:22

Er:22 indicates that the WFR 2460 washer subsystem terminated the spin cycle before it could complete. This is most commonly caused by excessive suds generated by too much detergent or the wrong type of detergent. The control system stops the spin phase automatically to protect internal components when it detects abnormal drum conditions. Checking detergent type and dosage is the recommended first step.

You should not ignore Er:22, as it means the spin cycle did not complete and laundry may be left overly wet inside the drum. While the error itself is often caused by a non-hazardous issue like over-sudsing, leaving it unaddressed can mask an underlying mechanical or electrical fault. Continuing to operate the appliance without resolving the root cause could lead to additional component wear.

If the cause is simply incorrect detergent use, the fix costs nothing beyond switching products. If a component such as a door latch, wiring harness, or motor control board needs replacement, repair costs can range from around $75 to $400 or more depending on the part and labor involved. Getting a diagnostic assessment from a certified technician will help determine the exact scope of the repair before committing to parts.

Start by reviewing the amount and type of detergent being used. Switch to a high-efficiency detergent and reduce the dosage to the minimum recommended amount for the load size. If the error persists after correcting the dosing, inspect the door latch, wiring, and motor circuit for faults. A qualified technician should perform electrical component testing if the issue continues.

A reset may clear the displayed code temporarily, but the error will return if the underlying cause is not addressed. If the spin termination is due to excessive suds, correcting the detergent dosing before the next cycle is necessary. For hardware-related causes such as a faulty latch or motor issue, a reset alone will not resolve the problem.