Whirlpool Range Error Code F2E1

F2E1 means the control board has detected a shorted or stuck key on the keypad. This code is specific to Whirlpool ranges using LCC/LCX and Indigo controls. The control sees a key input being held active for an extended period and locks out normal operation until the condition is cleared.

In most cases, F2E1 will prevent the range from accepting normal keypad input, making it non-functional or unreliable until the fault is cleared. You should not attempt to operate the range while this error is active, as the control system is flagging an input fault that could interfere with proper oven or cooktop operation.

If F2E1 returns every time you restore power, the fault is persistent within the HMI-Central/UI board Control Panel Assembly itself, either due to a failed keypad membrane, internal short in the board, or moisture damage. A power reset only clears temporary electrical glitches. A recurring F2E1 after reset is a reliable indicator that the Control Panel Assembly must be replaced rather than reset again.

Start by disconnecting power to the range at the circuit breaker or by unplugging it, wait 30 seconds, then restore power. If F2E1 does not return, the issue was a temporary glitch. If the code comes back, inspect the control panel for any visibly stuck or debris-covered keys and clean around them carefully. If the code persists after cleaning and a power reset, the HMI-Central/UI board Control Panel Assembly needs to be replaced.

If a power reset clears the code, there is no cost. If the HMI-Central/UI board Control Panel Assembly needs replacement, the part typically costs between $100 and $300 depending on the specific Whirlpool model, plus one to two hours of labor if a technician performs the swap. The Control Panel Assembly on most Whirlpool ranges is a single replaceable unit, and an experienced DIYer with basic appliance repair skills can often complete this repair without professional help.