Whirlpool Washer, Dryer Error Code Drying + Cool Down + Finish Guard (flashing)

This flashing LED combination means the dryer detected that a power failure occurred while a drying cycle was in progress. It is a notification from the control board, not a component fault. The dryer does not automatically resume the interrupted cycle. Press ON/SELECT or CANCEL to clear the flashing lights.

Yes, it is safe to continue using the dryer once you clear the flashing LEDs. The notification indicates a past power interruption, not an internal failure or safety hazard. However, if the code appears frequently without an obvious cause like a storm or outage, have your electrical circuit inspected before continued use to rule out wiring problems.

Repeated occurrences of this flashing pattern suggest that the dryer is experiencing intermittent power loss during operation. The most likely causes are a tripped or weak circuit breaker, a loose power cord connection at the outlet or terminal block, or an unreliable wall outlet. Inspect the power cord for a firm connection at both ends and check the breaker panel for any tripped breakers. If the issue continues, have a qualified electrician evaluate the outlet and circuit.

Yes, pressing ON/SELECT or CANCEL will clear the flashing LEDs and return the dryer to a ready state. After clearing the display, you can start a new cycle normally. If the flashing pattern returns repeatedly, investigate the power supply circuit for intermittent connection issues.

In most cases there is no repair cost at all, since this condition is caused by a power interruption rather than a failed part. If the root cause turns out to be a faulty wall outlet or circuit wiring, electrician fees can range from $75 to $250 or more depending on the extent of the work. Parts replacement is rarely required for this specific notification.