Whirlpool Washer Error Code F22

F22 on a Whirlpool washer means the door lock failed to confirm a secured position. The washer attempts the locking procedure and, if it fails to detect a successful lock after cycling through the sequence twice, it displays F22 and stops. This is a safety feature that prevents the machine from running a wash cycle with the door unsecured.

Clearing the error code and restoring power may temporarily dismiss the F22 display, but the code will return if the underlying problem is not corrected. If the door hook is damaged or the latch is loose, the washer will fail to lock again on the next cycle and store the fault again. A reset is useful as a first diagnostic step, but it is not a permanent fix.

Repair costs vary depending on the failed component. If only the door hook or latch mounting needs adjustment, there may be no parts cost at all. A replacement door lock assembly typically runs in the range of $30 to $80 for the part alone. If a technician is needed, expect to add $100 to $200 or more for labor, depending on your location and the service provider.

Many F22 causes are DIY-friendly. Start by unplugging the washer, then closely inspect the door hook for bending or damage and confirm the latch assembly is firmly mounted to the front panel. If the physical components look correct, check the wiring connector at the lock assembly for corrosion or loose terminals. Replacing the door lock assembly is also a common DIY repair that requires basic tools and an exact-match replacement part.

No. The washer displays F22 specifically because it cannot confirm the door is locked, and it will not start a cycle in this state. Attempting to force or bypass the lock to run a load is not recommended, as an unsecured door during a cycle can result in water leaking onto the floor. Address the latch or door hook issue before running the machine.