Error code reference

Whirlpool Washer Error Code F26

Door switch error-door has not been opened for 3 consecutive cycles or door switch is open while door is locked for more than 5 seconds; indicated during Diagnostic Test only, buzzer beeps three times during normal operation.

Diagnostic procedure

The full F26 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Open and close the door; verify CCU operation by running a Diagnostic Test or any cycle.

SourceWhirlpool WFW9400SW04 - Tech Sheet: Diagnostic & Troubleshooting Guidep. 4

More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock F26 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

66 manuals in the MyPros+ library document this code for Whirlpool washer.

Models covered by the manuals that document this code

More models are covered than are listed here.

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax