Wolf Cooktop Error Code E50

E50 indicates that the heatsink thermistor inside the power module is reading an open circuit value, meaning the sensor appears to be disconnected or has failed. The cooktop shuts down when this error occurs to prevent unmonitored operation of the power module. The primary repair is replacement of the power module assembly.

No. E50 indicates the power module's thermal protection sensor has failed, meaning the cooktop can no longer monitor the temperature of the power module. Continuing to operate the cooktop without this protection in place could result in overheating of internal components. The cooktop should remain off until the fault is repaired.

Repair costs vary depending on labor rates in your area and the specific power module part required, but homeowners should generally expect to spend somewhere in the range of $300 to $700 or more for a power module replacement including parts and labor. Wolf cooktop components are premium parts, and obtaining an accurate estimate from an authorized service provider before proceeding is recommended.

Resolving E50 typically requires replacing the power module, which involves working inside the cooktop with components that handle high voltage. This repair is best performed by a qualified appliance technician. A homeowner comfortable with appliance repair may be able to inspect wiring connectors first, but component replacement should be approached with caution given the electrical hazards involved.

A reset, such as cycling power at the breaker, may temporarily clear the displayed error, but E50 will return if the underlying hardware fault has not been corrected. Because the cause is a failed or open thermistor circuit rather than a software or transient issue, the fault will persist until the power module or associated wiring is repaired or replaced.