Model reference
Amana 11-3D
Air Conditioner
3 documents50 error codes19 service modes
Available documentation
Service Manual
- servicemanual-w11197006-27_stackedlaundrycenter82 pg
Tech Tip
- Instruction Sheet - 8576573 - Rev A16 pg
- Instruction Sheet16 pg
MyPros+ Max
Diagnose your Amana 11-3D.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (50)
CodeMeaning
03/08Door and switches do not agree (door position disagreement).11Oven sensor opened (upper oven bake/broil circuit).12Oven sensor shorted (upper oven bake/broil circuit).1CShorted key detected on keypad.1dBake/Broil range over temperature condition (alternate display code).21Oven sensor opened (lower oven circuit).22Oven sensor shorted (lower oven circuit).2CKeytail unplugged.31Latch error during CLEAN mode.32Latch error during CLEAN mode.3dBake/Broil range over temperature condition.4dInternal control error.51Clean range over temperature condition.52Clean range over temperature condition.6CEEPROM communications error.7CInternal control error.8CInternal control error.9dDoor latch not operating properly.F-01Primary control failure in the machine control electronics.F-02Stuck button or user interface mismatch (only appears in diagnostic test mode).F-22Exhaust thermistor circuit is open.F-23Exhaust thermistor has shorted.F-26Motor drive system failure.F-28Moisture sensor strip is open (only appears in diagnostic test mode).F-29Moisture sensor strip has shorted (only appears in diagnostic test mode).F0E2Oversuds condition detectedF0E4High water temperature detected during rinse cycle (water temperature…F0E5Off balance load detected.F1E1Primary control failure indicating the machine control electronics has failed.F1E2Motor control faultView all 50 error codes
F2E1Stuck button or user interface mismatch; this fault code will ONLY appear when…F2E3Switch mismatchF3E1Exhaust thermistor is open.F3E2Exhaust thermistor has shorted.F3E6Moisture sensor strip is open; this fault code will ONLY appear when in the…F3E7Moisture sensor strip has shorted; this fault code will ONLY appear when in the…F4E4Low line voltage detected.F5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill / long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F9E1Long drainPFA power failure occurred while the dryer was running.
Service modes (19)
- Automatic Test Mode["1
- Calibration Mode["1
- Customer-Focused Drying Mode Adjustment["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the DONE…
- diagnostic1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Cycle…
- Diagnostic Test Mode1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only Cycle Complete…
- Dryness Level Adjust Mode (TEST #4a)1. Activate the diagnostic test mode and advance past saved fault codes. 2. In diagnostic test…
- Dryness Level Adjustment Mode (TEST #4a)1
- dryness_level_adjust1
- Engineering ModePress UPPER BAKE, enter 100 on the keypad, then press and hold UPPER BAKE for three (3) seconds.
- Fault Code Display Mode["1
- Manual Test Mode["1
- Service Diagnostic Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the DONE…
- Service Diagnostic Test Mode Entry["1. Ensure washer/dryer is in standby mode (plugged in with all indicators off).","2. After…
- Service Diagnostic Test Modes (Washer) - Entry["1. Ensure washer/dryer is in standby mode (plugged in with all indicators off).","2. After…
- Software Version Display Mode["1
- Tachometer Verification Mode["1
- Temperature Adjustment ModePress BAKE key for three (3) seconds, then enter 550
- UI Test Mode["1
- User Interface/Control System Test["First activate Service Diagnostic Mode (see above).","Press and release the 1st button used to…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana air conditioner models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass