Model reference
Amana 5P-2M-1W/P54972-8R
Air Conditioner
31 error codes8 service modes
MyPros+ Max
Diagnose your Amana 5P-2M-1W/P54972-8R.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (31)
CodeMeaning
:Power failure indication0No code present (no fault detected).14Heater on and drum temperature not increasing.15Thermistor out of range.16Thermistor possible open.17Thermistor possible short.18Motor thermal protector opened more than 5 times during cycle.20Dryer over temp without shutdown.21Selected dryer temperature not reached.22Dryness sensor bar possibly open.23Dryness sensor bar possibly shorted.24Incorrect rotary switch position seen.25Rotary Switch 1 left of encoder failed at startup.26Rotary Switch 2 left of encoder failed at startup.28Rotary Switch 3 left of encoder failed at startup.3Door switch error (power failure / door switch code).31Model ID Unknown, default used at startup.F1.E1Relay control board defective.F2Membrane switch failure.F2.H1Hood keys stuck.F2.H2Hood/light switch defective.F2.Q1Not reading keypad inputs.F3.H1Humidity sensor failure.F3.T1UIB (user interface board) thermistor failure.F3.T2FC (forced convection) thermistor failure.F3.T4Magnetron thermistor failure.F3HHumidity sensor failure.F6MW relay failure.F7Power to magnetron interrupted.F9Relay control board communications error.View all 31 error codes
Service modes (8)
- Console Switch Test["Enter Service Mode.","Set Cycle Selection Knob to 'Wrinkle Prevent' and press knob.","Power Off…
- Display/Clear Service Codes["Enter Service Mode.","Set Cycle Selection Knob to 'Time Dry 10' and press knob.","Time Dry 10 LED…
- Service Cycle["Enter Service Mode.","Set Cycle Selection Knob to 'Regular' and press knob.","Cool Down LED…
- Service Mode1
- Service Mode Entry["Rotate the Cycle Selector Knob to the 'Power Off' position and press knob (all LEDs will be…
- Test Mode (Diagnostic)["1
- Test Mode (Touch Panel and Relay Control Board Tests)["1
- Touch Panel and Electronic Control Self-Diagnostic Test Mode["Press and hold STOP/Clear while opening the door.","While still holding the STOP/Clear button…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana air conditioner models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass