mypros+
Model reference

Amana C58390-25/P58390-25C

Air Conditioner

23 error codes12 service modes
MyPros+ Max

Diagnose your Amana C58390-25/P58390-25C.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (23)

CodeMeaning
F0E0No fault codes stored in memory.F0E2Over suds condition detected; suds prevent basket from spinning up to speed or…F0E4High water temperature detected during rinse cycle (water temperature 40.5°C /…F0E5Off balance load detected during operation.F1E1Main control fault detected.F1E2Motor control fault; fault of the motor control section of the main control.F2E1Stuck key; one or more keys on the User Interface were actuated for 15…F2E3Mismatch of main control and user interface; the UI identification does not…F3E1Pressure sensor fault; main control detects an out of range pressure signal.F3E2Inlet water temperature fault; inlet thermistor detected to be open or shorted.F5E1Lid switch fault; lid is in locked state but lid switch is open, or main…F5E2Lid lock fault; lid lock has not moved into locked position or motor cannot be…F5E3Lid unlock fault; lid lock has not moved into unlocked position or motor cannot…F5E4Lid not opened between cycles; user presses START after several consecutive…F7E1Basket speed sensor fault; main control cannot determine speed of basket or…F7E5Shifter fault; main control cannot determine position of shifter.F7E6Motor fault; indicates an open clockwise or counterclockwise circuit of the…F7E7Motor unable to reach target RPM; basket speed sensor detects that target RPM…F8E1No fill / long fill; water level does not change for a period of time or water…F8E3Overflow condition; main control senses water level that exceeds the washer's…F8E5Hot and cold inlet hoses are reversed.F9E1Long drain; water level does not change after the drain pump is on for 10…Stuck KeyThe control detects that a key is stuck in the depressed position; dishwasher…

Service modes (12)

  • Automatic Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs show
  • Calibration Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs show
  • Diagnostics Test CycleWithin 10 seconds, press
  • Fault Code Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs show
  • Manual Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs show
  • Rapid Advance (Service Mode)After a cycle has started, enter
  • Sales Demo CycleWithin 10 seconds, press
  • Service Diagnostic Test Mode Entry["Ensure washer is in standby mode (plugged in with all indicators off).","RESET
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","RESET
  • Software Version Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs show
  • Tachometer Verification Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs show
  • UI Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs show

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax