Model reference

Amana CR3-1/P58094-15C

Air Conditioner

29 error codes1 service mode

MyPros+ Max

Diagnose your Amana CR3-1/P58094-15C.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (29)

CodeMeaning

AXIAL PROBE FAULTProblem with the axial temperature sensor circuit.BURNER CONTROL FAULTGas return valve signal did not turn on before DSI purge time expired or turned…BURNER HIGH-LIMIT FAULTBurner high-limit switch opened during the cycle while the heat was on.BURNER PURGE FAULTGas return signal detected before the heat signal was sent out by the…CHECK CONTROL BOARD FUSE #2Main fuse (fuse 2) on the Phase 7 computer board has opened; controller will…CLEAN LINTLint drawer has not been opened within the programmed Lint Cleaning Frequency…DISCONNECTED WATER VALVES.A.F.E error1Shorted sensor circuit.error2Open sensor circuit.error3On the cooling mode, sensor's Vout was not less than 4.7V within 3 minutes.error4On the way to sensing, the door was opened.EXHAUST HIGH TEMP FAULTTemperature sensor input shows overheating with steady gradual increase to a…EXHAUST HIGH-LIMIT FAULTTumbler safety over-temperature switch has opened.EXHAUST PROBE FAULTProblem with the exhaust temperature sensor circuit.FLAME FAULTGas valve return signal was lost after the DSI proof time, occurring five…IGNITION FAULTGas valve return signal was lost during the DSI proof time and retry count has…LINT ACCESS OPENLint drawer is open and needs to be closed.MAIN DOOR OPENEDMain door is open when it should be closed.MODEL ERROR, ENTER CORRECT MODELController detected a mismatch between programmed dryer type and actual inputs…OPEN THERMISTOR PROBES.A.F.E ROTATION SENSOR FAULTTime between rotational sensor pulses exceeded 10 seconds, indicating tumbler…S.A.F.E. SYSTEM ACTIVATEDPhase 7 controller has detected a fire and is currently extinguishing the flame.S.A.F.E. SYSTEM DISABLEDA fault in the S.A.F.E S.A.F.E. SYSTEM WAS ACTIVATEDPhase 7 controller detected a fire and has extinguished the flame.SAIL SWITCH CLOSED FAULTSail switch is in the closed position prior to starting; switch did not open…SAIL SWITCH OPEN FAULTSail switch did not close within 8 seconds of starting/restarting, or sail…SHORTED THERMISTOR PROBES.A.F.E SHORTED WATER VALVES.A.F.E WATER NOT CONNECTEDNo water pressure at the S.A.F.E

Service modes (1)

S.A.F.E. System Diagnostic DisplayWhen the display reads 'S.A.F.E

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax