mypros+
Model reference

Amana SCFC42HOH-A/P68598-7C

Air Conditioner

5 documents28 error codes5 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10159200A6 pg
    Covers this model

Tech Tip

  • Instruction Sheet2 pg
    Covers this model

Installation Guide

  • Installation Instructions2 pg
    Covers this model
  • Installation Instructions6 pg
    Covers this model
  • Installation Instructions20 pg
    Covers this model
MyPros+ Max

Diagnose your Amana SCFC42HOH-A/P68598-7C.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (28)

CodeMeaning
03/08Door and switches do not agree (door position disagreement).11Oven sensor opened (upper oven bake/broil circuit).12Oven sensor shorted (upper oven bake/broil circuit).1CShorted key detected on keypad.1dBake/Broil range over temperature condition (alternate display code).21Oven sensor opened (lower oven circuit).22Oven sensor shorted (lower oven circuit).2CKeytail unplugged.31Latch error during CLEAN mode.32Latch error during CLEAN mode.3dBake/Broil range over temperature condition.4dInternal control error.51Clean range over temperature condition.52Clean range over temperature condition.6CEEPROM communications error.7CInternal control error.8CInternal control error.9dDoor latch not operating properly.E0 F1EEPROM communications failure, typically caused by power line noise or…E0 F3Key contact closed for more than 60 secondsE0 F3 (sensor open)Break in oven sensor circuitE0 F5Door switch open during cleanE1 F2EEPROM checksum failure, typically caused by power line noise or lightning.E1 F3No communication between keyboard and controlE1 F3 (sensor short)Short in oven sensor circuitE1 F5Door latch not operatingE2 F3Bake/Broil temperature out of range (too high)E3 F3Clean temperature out of range (too high)

Service modes (5)

  • Engineering ModePress UPPER BAKE, enter 100 on the keypad, then press and hold UPPER BAKE for three (3) seconds.
  • Manual Diagnostics Mode 1 (Full)Within 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then Start.
  • Manual Diagnostics Mode 2 (Limited)After 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then Start.
  • Temperature Adjustment (Calibration)Press and hold BAKE pad for 5 seconds
  • Temperature Adjustment ModePress BAKE key for three (3) seconds, then enter 550

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass