Model reference
Amana ESMC-1-A/P18011-4TA
Compactor
48 error codes10 service modes
MyPros+ Max
Diagnose your Amana ESMC-1-A/P18011-4TA.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (48)
CodeMeaning
F0E0No error(s) foundF0E2Oversuds condition detectedF0E3Overload detectedF0E4Spin limited by water temperatureF0E5Off balance load condition detected.F0E7Load detected when running Clean Washer cycle.F0E8Water ring faultF0E9Off balance pauseF1E0Internal failureF1E1Main control (ACU) fault detected.F1E2Internal failureF1E3Internal failureF1E4Internal failureF1E5Internal failureF1E6Internal failureF2E0Keypad disconnected.F2E1HMI stuck buttonF2E2HMI disconnected from the ACU.F3E2Pressure system faultF3E3Inlet water temperature faultF3E5Mini bulk system errorF4E1Microwave convection thermistor failure.F4E2Microwave internal temperature sensor failure.F4E4Microwave humidity sensor failure.F4E5Weight sensor not within normal value.F4E6Microwave wave-guide heat sensor failure.F4E7Microwave probe failure.F5E0Door and latch switch do not agree.F5E1Lid switch faultF5E3Lid lock will not unlockView all 48 error codes
F5E4Lid not opened between cyclesF6E0Lost communication between user interface and appliance manager(s).F6E1Communication errorF6E2Clean oven over temperature.F6E3Mini oven/warm drawer over temperature (not for built-in ovens).F6E4User interface / appliance manager mismatch.F6E5Cavity size is incorrect.F7E1Tachometer missing or wrong signalF7E3Basket engaged during washF7E4Basket re-engagement failureF7E6Motor circuit openF7E7Motor unable to reach target RPM.F8E0Low fan speed underspeedF8E1Long fillF8E2Dispenser system failureF8E3Overflow or flood conditionF8E6Water hazardF9E1Drain pump system problem
Service modes (10)
- Component ActivationEnter Service Mode, navigate to Service Diagnostics, select Component Activation
- Diagnostic CycleEnter Service Mode, navigate to Service Diagnostics, select Diagnostic Cycle.
- Diagnostics ModePress any 3 keys 3 times within 8 seconds.
- DLMS Calibration CycleEnter Service Mode, navigate to Factory Diagnostics, select DLMS Calibration Cycle.
- Error DiagnosticFrom the Diagnostics Home Menu, press Up/Down navigation buttons to highlight Error Diagnostic…
- Fault HistoryEnter Service Mode, navigate to Fault History
- HMI TestEnter Service Mode, navigate to Service Diagnostics, select HMI Test
- Sensor FeedbackEnter Service Mode, navigate to Service Diagnostics, select Sensor Feedback
- Service Mode1. Ensure washer is in standby mode (plugged in with all indicators off). 2. Select any three…
- System InformationFrom the Diagnostics Home Menu, press Up/Down navigation buttons to highlight System Info, then…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana compactor models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax