Model reference

Amana OY-106-ES

Furnace

2 documents35 error codes4 service modes

Available documentation

Installation Guide

Instrucciones de instalacion9 pg
Covers this model
Installation Instructions16 pg
Covers this model

MyPros+ Max

Diagnose your Amana OY-106-ES.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Furnace

001 on my Amana OY-106-ES

M+

Fridge/Cellar compressor failure —

From Tech Sheet W13852049, p.21:

1.Access service mode to confirm the active fault code and read stored error history.

2.Disconnect the sensor and measure resistance. Expected: 10 kΩ to 12 kΩ at 77°F (25°C).

3.Check the sensor harness for opens. A reading outside 5 kΩ to 50 kΩ indicates a failed sensor.

Part WP8577274

Temperature thermistor

Error codes (35)

CodeMeaning

001Fridge/Cellar compressor failure 002TriMode (freezer) compressor failure 003Condenser overheating 004TriMode defrost heater failure 005TriMode fan / air circulation failure 006Fridge gas solenoid performance issue 007Fresco gas solenoid performance issue 008No water fill 012Fresco NTC air probe fault 013Fresco NTC evaporator probe fault 014Fresco fan / air circulation failure 015Ice maker NTC probe fault 016Condenser NTC probe fault 018Fridge fan / air circulation failure 019Fridge NTC air probe fault 020Fridge NTC evaporator probe fault 021Fridge magnetic door switch fault 022TriMode magnetic door switch fault 023TriMode NTC evaporator probe fault 024TriMode NTC air probe fault 025No PCB communication F0E0No fault detected (GOOD)F3E1Lower oven sensor shorted or open.F3E3Meat probe shorted.F4E1Convection thermistor fault (microwave oven sensor).F4E2Internal temperature sensor fault (microwave oven sensor).F4E4Humidity sensor fault (microwave oven sensor).F5E0Door and latch switch do not agree.F5E1Door latch not operating.F6E0Lost communications between user interface and appliance manager.

View all 35 error codes

F6E3Mini oven/warm drawer over temperature (function not present on this oven).F6E4User interface / appliance manager mismatch.F6E5No cavity size command programmed.F7E0Water level is not high enough or water did not boil fast enough.F7E4Conductivity sensor not connected.

Service modes (4)

Diagnostic modePress OFF, OFF, START to enter diagnostic mode and check fault codes.
Extended diagnostic mode (relay activation and testing)1
Service Diagnostics Mode["Go to the Home screen and touch the Settings icon.","Touch the Service icon.","Touch the YES…
User interface programming (after UI replacement)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana furnace models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass