mypros+
Model reference

Amana RC-10B-PB/P73547-16M

Microwave

6 documents49 error codes12 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W1037157520 pg
    Covers this model
  • Tech Sheet - W10419696 - Rev A28 pg
    Covers this model
  • Commercial Microwave Technical Information10 pg
    Covers this model
  • Tech Sheet16 pg
    Covers this model

Tech Tip

  • Instruction Sheet - 818443020 pg
    Covers this model
  • Instruction Sheet - 816969620 pg
    Covers this model
MyPros+ Max

Diagnose your Amana RC-10B-PB/P73547-16M.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (49)

CodeMeaning
:Flashing colon indicates a power failure has occurred.CThermistor failureCFCommunication failure between the main control board and the user interface.dAir door (damper) stuck or open circuit detected.F0E1Load detected in drum during Clean Washer cycle.F0E2Excessive suds detected in washer; washer is running a suds reduction routine.F0E4High temperature error during wash cycle.F0E5Off balance load detected.F1.E1Relay Control Board defective.F12E0Communication between the Human Machine Interface and Wi-Fi Module has not been…F1E1Main relay open or shorted.F1E2MCU over- or under-voltage error.F2Touch panel failure.F2.H1Hood/light switch stuck.F2.H2Hood/light switch error.F2.Q1User interface board (UIB) is not reading keypad inputs.F3.H1Humidity sensor failure.F3.T1UIB (user interface board) thermistor failure.F3.T2FC (forced convection) thermistor failure.F3.T4Magnetron thermistor failure.F3E1Pressure sensor signal missing or out of range.F3E2Wash NTC (thermistor) open or shorted.F3E5Dry NTC open circuit fault; dry temperature sensor out of range, open circuit…F3E6Accelerometer error.F3HHumidity sensor failure.F4E1Wash heater relay error or no feedback signal; ACU cannot detect temperature…F4E2Wash heater relay error.F4E4Blower error.F5E2Door lock failure.F5E3Door unlock failure.
View all 49 error codes
F5E4Door not open error.F6MW relay failure (Relay 4903 on Relay Board).F6E1No communication from the HMI detected by ACU.F6E2No communication from the ACU detected by the HMI.F6E3No communication from the MCU detected by the ACU.F7Power to magnetron interrupted.F7E10Motor disconnected error.F7E12MC/MCU overload.F7E2MC/MCU over temperature error or over current error/internal failure.F7E8MC/Motor over temperature error.F7E9Motor will not turn (locked rotor).F7EAMotor disconnected error (alternate display of F7E10).F7ECMC/MCU overload (alternate display of F7E12).F8E1Water inlet valve failure.F8E3Overflow condition detected.F9Relay Control Board communications error.F9.QTouch communication error.F9E1Long drain time detected.FCE0Communication between the Human Machine Interface and Wi-Fi Module has not been…

Service modes (12)

  • Clear Error History["Enter Service Diagnostic Mode.","From the DIAGNOSTICS HOME screen, press CLEAR ERROR HISTORY…
  • Component Activation (Manual)["Enter Service Diagnostic Mode (see entry procedure above).","From DIAGNOSTICS HOME screen, press…
  • Fault/Error Code Display["Enter Service Diagnostic Mode.","From the DIAGNOSTICS HOME screen, press ERROR DIAGNOSTIC…
  • Human-Machine Interface Test["First activate Service Diagnostic Mode.","Press and release the 1st button used to activate…
  • Quick Diagnostic Test["First activate Service Diagnostic Mode.","Press and release the 2nd button used to activate…
  • Quick Service Cycle["Enter Service Diagnostic Mode.","From DIAGNOSTICS HOME, press Component Activation.","Select…
  • Self Diagnostic Mode (power-up)Disconnect power to the refrigerator for 10 seconds, then reconnect power
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Open and close the…
  • Software Version Display["Enter Service Diagnostic Mode.","From DIAGNOSTICS HOME, press System Info.","Select Software…
  • Test Mode (Touch Panel and Relay Control Board Tests)["1
  • Touch Panel and PCBA Self-Diagnostic Test Mode["1
  • Touch Panel Test Mode["1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana microwave models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass