Model reference
Amana RRH-10/P73863-1M
Microwave
2 documents41 error codes11 service modes
Available documentation
Tech Tip
- Instruction Sheet - 3978720 - Rev A12 pg
- Instruction Sheet2 pg
MyPros+ Max
Diagnose your Amana RRH-10/P73863-1M.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (41)
CodeMeaning
AFLow inlet air flow detected at install.F:01Primary control failure.F:02Stuck button or user interface mismatch (appears ONLY in Diagnostic Test Mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:24Inlet thermistor is open (appears ONLY in Diagnostic Test Mode).F:25Inlet thermistor is shorted (appears ONLY in Diagnostic Test Mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (appears ONLY in Diagnostic Test Mode).F:29Moisture sensor strip has shorted (appears ONLY in Diagnostic Test Mode).F:30Restricted air flow condition exists (appears ONLY in Diagnostic Test Mode).F:31Low voltage condition (less than 30 V) detected (appears ONLY in Diagnostic…F:50No voltage detected at the water valve relay (appears ONLY in Diagnostic Test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).F:78Console electronics failure (F:72 through F:78).F1 E0EEPROM communications failure.F1 E1EEPROM checksum failure.F1 E2UL A/D error(s).F2 E0UL A/D error(s).F2 E1Keytail unplugged (shorted key condition).F3 E0Oven sensor opened.F3 E0 (door/latch)Door and latch switches do not agree.View all 41 error codes
F3 E1Oven sensor shorted.F3 E1 (door/latch)Solenoid not operating or latch switch failure.F3 E2Bake range over temperature.F3 E2 (door/latch)Latch during CLEAN error.F3 E3Clean range over temperature.F5Shorted key detected on keypad.F5 E0Door and latch switches do not agree.F5 E1Solenoid not operating or latch switch failure.F5 E2Latch during CLEAN error.L2Low line voltage (less than 30 V) detected at installation.PFPower failure occurred while the dryer was running.
Service modes (11)
- Clear F-failure Code from Memory["Press and hold any key for 1 minute to clear the F-failure code from memory.","F2 will…
- Customer-Focused Drying Mode Adjustment["In Standby mode (dryer plugged in but not powered up), press and hold the Dryness Level button…
- diagnostic["Set Fabric Care / Temperature switch to AIR FLUFF / NO HEAT","Set Signal switch to LOUDER","Set…
- diagnostic_test["Ensure door is open.","Set Fabric Care / Temperature switch to AIR FLUFF / NO HEAT.","Set Signal…
- Last error code recallPress and hold CANCEL/OFF key for 5 seconds until last error code is displayed.
- less_dry_test["Begin with a fully assembled, empty dryer with clean lint screen connected to known good power…
- Manual Load Test["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
- Oven temperature calibrationPress and hold the BAKE keypad for 5 seconds
- Service Diagnostic Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
- Temperature Calibration AdjustmentPress and hold BAKE pad for 5 seconds. Current offset (if any) is shown in 3-digit display. CAL is…
- View Last Error Code["Press and hold the CANCEL/OFF key for 5 seconds.","The last error code will be displayed."]
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana microwave models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass