Model reference

Amana RCC-4-A1/P72778-2MA

Oven

5 documents25 error codes7 service modes

Available documentation

Tech Sheet

tech sheet 8301824 fr8 pg
Covers this model

Service Manual

ADC AD-75THS ServiceManual-PH5 PastProduction OPL73 pg
Covers this model

Installation Guide

Installation Instructions4 pg
Covers this model
Installation Instructions26 pg
Covers this model

Other

ELECTRIC COOKTOP Use & Care Guide28 pg
Covers this model

MyPros+ Max

Diagnose your Amana RCC-4-A1/P72778-2MA.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Oven

dOOr on my Amana RCC-4-A1/P72778-2MA

M+

Door switch circuit is open, either due

From Tech Sheet W13463161, p.13:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part W10810403

Door lock assembly

Error codes (25)

CodeMeaning

dOOrDoor switch circuit is open, either due to keyboard entry made while main door…dSFLFault detected in the microprocessor temperature sensor circuit; buzzer will…F0-E0Default code indicating no fault present.F1-E0Electronic control module failure.F1-E1Electronic control module failure.F1-E2Electronic control module failure.F1-E3Electronic control module failure.F1-E4Electronic control module failure.F2-E0Keypad not connected.F2-E1Keypad not connected.F2-E2Prolonged key press or short circuit on keypad.F3-E0Lower temperature sensor open circuit.F3-E1Lower temperature sensor short circuit.F3-E2Microwave temperature sensor open circuit.F3-E3Microwave temperature sensor short circuit.F5-E0Excessive temperature in lower cavity during self-clean cycle.F6-E0Excessive temperature in lower cavity during bake mode.F6-E1Excessive temperature in microwave oven during cooking.F8-E0Self-clean latch unable to unlock.F8-E1Self-clean latch unable to unlock.F8-E2Excessive temperature in oven with door open and latch locked.F8-E3Excessive temperature in oven with door open and latch unlocked.F8-E4Excessive temperature in oven with door closed and latch unlocked.HotPossible overheating condition detected; the microprocessor controller has…SEFLRotational sensor circuit failure indicating a fault in the basket (tumbler)…

Service modes (7)

Fault code displayPress and hold the UPPER OFF button for 5 seconds.
Hot condition manual resetAfter temperature drops to 220°F or lower, manually close and then open the program switch (PS) on…
Microwave power output test1
Phase 5 Coin System DiagnosticsThe Phase 5 coin microprocessor controller automatically monitors all major circuits including…
Sabbath modeSabbath mode is indicated by 'SAB' symbol on the display.
Temperature offset calibrationAdjust temperature offset in increments of 3°C or 5°F
Temperature unit conversion (F/C)Press and hold the BROIL button for 5 seconds to switch to Celsius (indicated by 'C' on display).

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass