Model reference

Amana TAA600/P75751-16W

Washer

7 documents25 error codes3 service modes

Available documentation

Tech Sheet

Wiring Diagram - W10850075 - Rev B2 pg
Covers this model
Wiring Diagram - W10903850 - Rev A2 pg
Covers this model
wiring-sheet-W10917793-RevA.pdf2 pg
Covers this model
Wiring Diagram - W10873902 - Rev A1 pg
Covers this model
Wiring Diagram - W10873907 - Rev A2 pg
Covers this model
wiring-sheet-W10902662-RevA.pdf2 pg
Covers this model
Wiring Diagram2 pg
Covers this model

MyPros+ Max

Diagnose your Amana TAA600/P75751-16W.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Washer

AF on my Amana TAA600/P75751-16W

M+

Low inlet air flow detected at install.

From Tech Sheet W17677211, p.23:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

AFLow inlet air flow detected at install.F:01Primary control failure.F:02Stuck button or user interface mismatch (appears ONLY in Diagnostic Test Mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:24Inlet thermistor is open (appears ONLY in Diagnostic Test Mode).F:25Inlet thermistor is shorted (appears ONLY in Diagnostic Test Mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (appears ONLY in Diagnostic Test Mode).F:29Moisture sensor strip has shorted (appears ONLY in Diagnostic Test Mode).F:30Restricted air flow condition exists (appears ONLY in Diagnostic Test Mode).F:31Low voltage condition (less than 30V) detected (appears ONLY in Diagnostic Test…F:50No voltage detected at the water valve relay (appears ONLY in Diagnostic Test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure.F:73Console electronics failure.F:74Console electronics failure.F:75Console electronics failure.F:76Console electronics failure.F:77Console electronics failure.F:78Console electronics failure.L2Low line voltage (less than 30V) detected at installation.PFPower failure occurred while the dryer was running.

Service modes (3)

Customer-Focused Drying Mode Adjustment1
Diagnostic Test Mode1
Manual Load Test1. Dryer must be in standby mode (plugged in with all indicators off, or with only the Clothes Dry…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass