mypros+
Model reference

Caloric DCS215-1H

Dishwasher

25 error codes9 service modes
MyPros+ Max

Diagnose your Caloric DCS215-1H.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (25)

CodeMeaning
d13Coin 2 errord16Generation 2 debit card reader errord5Coin 1 errord9Low voltage detection errorE3The heater cannot warm the water to the desired temperature within 90 minutes…E6NTC open circuit failure (only alarmed during on-line test).E7NTC short circuit failure (only alarmed during on-line test).F01MCC (Central Control Module) communication errorF11Motor Control Module (MCM) failureF20No water entry detectedF21Excessive drain timeF22Door lock errorF24Water temperature sensor errorF25Tachometer errorF26Door switch errorF27Overflow conditionF28Communication failure between MCC and MCM.F29Motor overheating detected.F30No description availableF31No description availableF33Pump disconnectedF34Load detected in the washer during the washer cleaning cycle.F70Communication failure between MCC and User Interface (UI).F73User Interface (UI) failureF74User Interface (UI) failure

Service modes (9)

  • Diagnostic Mode (Blink Mode)["First access Setup/Configuration Mode.","Press DELICATES & KNITS button for 1 second while one of…
  • Help Mode["PD models
  • Manual Overview Test["Enter Diagnostic Mode (Blink Mode).","Press WHITES button while the display is blinking."]
  • On-Line Check Mode (Service Diagnostics Cycle)1
  • Quick Drain and Spin["Enter Diagnostic Mode (Blink Mode).","Press COLORS button while the display is blinking."]
  • Quick Overview Test["Enter Diagnostic Mode (Blink Mode).","Press WOOLENS button while the display is blinking."]
  • Service Mode (Keypad/LED Test)Close the door, then within 60 seconds press RINSE ONLY and START/RESUME
  • Setup/Configuration Mode["PD models
  • Washer Cleaning Program["Enter Diagnostic Mode (Blink Mode).","Press BRIGHT button while the display is blinking."]

Full entry steps, exit procedures, and test sequences are available in Max.

Related Caloric dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax