Model reference

Electrolux Zanussi 604796

Dryer

1 document24 error codes5 service modes

Available documentation

Service Manual

Service Manual Trockner Edr 200055 pg
Covers this model

MyPros+ Max

Diagnose your Electrolux Zanussi 604796.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Electrolux Zanussi Dryer

E00 on my Electrolux Zanussi 604796

M+

No alarm - no fault condition stored.

From Service Manual 548316, p.48:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (24)

CodeMeaning

E00No alarm E21Condensate pump triac defective.E22Sensing circuit of the condensate pump triac defective.E31Conductivity sensor signal frequency too high.E32Conductivity sensor signal frequency too low.E41Door opening solenoid supply triac defective.E42Sensing circuit of the door opening solenoid supply triac defective.E43Incongruence of the door lock sensing signal.E51Motor triac short-circuited.E52Motor thermal overload protection activated.E53Sensing circuit of the motor triac defective.E54Motor blocked.E61Insufficient heating (maximum time exceeded).E62Heating element supply relay defective.E63Auto-reset thermostat on the heating element has tripped.E71NTC temperature sensor malfunction.E81Error at the reset position of the program selector.E82Communication error between main electronics and display/control electronics.E93Appliance configuration error E94Drying program configuration error.E95Communication error between microprocessor and EEPROM.EB1Mains supply frequency outside acceptable limits.EB2Mains supply frequency too high.EB3Mains supply frequency too low.

Service modes (5)

alarm_read_and_clear["1. Enter diagnostic mode (see diagnostic entry sequence).","2. Turn program selector clockwise to…
conductivity_calibration["1. Turn program selector to switch on the appliance.","2. In setup mode, simultaneously press and…
demo["1
diagnostic["1
quick_alarm_read["1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Electrolux Zanussi dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass