mypros+
Model reference

Fisher & Paykel DD24DTI9N

Dishwasher

1 document28 error codes7 service modes

Available documentation

Service Manual

  • Dishdrawer DD60 DD24 Service Manual78 pg
    Covers this model
MyPros+ Max

Diagnose your Fisher & Paykel DD24DTI9N.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (28)

CodeMeaning
A09Sanitize cycle has not met the required wash temperature to sanitize the dishes.A1Water supply faultA3Tub cannot drainA6No spray arm detectedA7Auto recoveryE1Flood detectedF1Flood detectedF21Motor bridge over temperature fault.F24Motor stalled, stopped, or overloaded.F25Motor loss of phase.F30Invalid temperatureF31Over temperature faultF4Heater plate faultF51Lid motor not turningF52Lid motor undercurrentF54Lid motor not stallingF70Fill valve high current fault.F71Fill valve low current fault.F82Motor controller ADC check failure.F84Fill valve drive failure on the motor controller.F85Bridge temperature sensor fault on the motor controller.F86Motor bridge failure on the motor controller.F87Motor controller current sense error.F95Fan control failure on the wash controller.F97Rinse aid pump control failureFC0Motor controller communications faultFC1Wash controller communications faultFC3Inter-wash controller communications fault

Service modes (7)

  • Continuous Cycle["Enter diagnostic mode.","Press the >>CYCLE button 3 times. QUICK and SANITIZE LEDs will be…
  • Diagnostic Mode Entry["Open the tub and wait until the user flange display turns off (approximately 30 seconds).","Press…
  • Display Diagnostic (dP)["Enter diagnostic mode.","The display sub mode (dP) is the first sub menu, indicated by EXTRA DRY…
  • Fast Test Cycle["Enter diagnostic mode.","Press the >>CYCLE button twice. EXTRA DRY, QUICK and SANITIZE modifier…
  • Hardware Output Mode (HO)["Enter diagnostic mode.","Press the >>CYCLE button once to scroll to Hardware Output mode.","EXTRA…
  • Knock Sensitivity Adjustment (Integrated models only)["Enter the user preference menu (hold >>CYCLE and START for 4 seconds with drawer open).","While…
  • User Preference Settings["Ensure no wash is in progress, then open the drawer.","Press and hold the >>CYCLE and START…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Fisher & Paykel dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax