Model reference
Frigidaire FFTW4120SW
Washer
11 documents10 error codes13 service modes
Available documentation
Tech Sheet
- Washer Tech Data Sheet6 pg
Service Manual
- Technical Service Manual, Top Load Washer36 pg
- Technical Service Manual, Top Load Washer MODEL FFTW4120SW35 pg
- TOP-LOAD WASHING MACHINE Owner's Guide8 pg
- Owner's Guide - Top Load Washing Machine8 pg
Service Flash
- Softener Dispenser Leaking4 pg
Tech Tip
- E3/FD Fault Codes for Top Load Washer5 pg
- Testing Water Level Sensor2 pg
- Suspicious Water Concern1 pg
Installation Guide
- Installation of your Washer32 pg
Other
- FFTW4120SW 59956870188 pg
MyPros+ Max
Diagnose your Frigidaire FFTW4120SW.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (10)
CodeMeaning
C9PCB failure.CLThe lid was opened for more than 20 minutes with Control Lock function…E1Water fill time exceeds 60 minutes; water is not entering or entering slowly.E2Water drainage time exceeds 10 minutes; water is not draining.E3Lid is open during a cycle that requires the lid to be closed.E4The unit is out of balance during spin operation.E5Washer is not level; impact switch is being pressed by tub.F2PCB (main control board) failure.F8Water level sensor failure.FdLid lock failure.Service modes (13)
- diagnosticPress Soak button, Extra Rinse button, and Power button simultaneously.
- Test 1 - Display and LED TestEnter test mode (Soak + Extra Rinse + Power simultaneously)
- Test 2 - Washing Test (Motor and Rotation Directions)Enter test mode, then within 5 seconds press the Soil Level button.
- Test 3 - Spinning Test (Clutch and Pump)Enter test mode, then within 5 seconds press the Temp button.
- Test 4 - Inlet Valve Test and Software Version CheckEnter test mode, then within 5 seconds press the Fabric Softener button.
- Test 5 - Auto-Sensing CheckEnter test mode, then within 5 seconds press the Delay button.
- Test ModePress Soak button, Extra Rinse button, and Power button simultaneously
- test_1_display_checkEnter test mode (Soak + Extra Rinse + Power simultaneously). Test 1 runs automatically upon entry
- test_2_washing_testWithin 5 seconds after entering test mode, press the Soil Level button.
- test_3_spinning_testWithin 5 seconds after entering test mode, press the Temp button.
- test_4_inlet_valve_and_software_versionWithin 5 seconds after entering test mode, press the Fabric Softener button.
- test_5_auto_sensing_checkWithin 5 seconds after entering test mode, press the Delay button.
- water_level_frequency_checkHold Soak and Extra Rinse button, and press Power to enter test mode
Full entry steps, exit procedures, and test sequences are available in Max.
Related Frigidaire washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass