mypros+
Model reference

GE JCKP18

Oven

4 documents9 error codes10 service modes

Available documentation

Service Manual

  • TECHNICAL SERVICE GUIDE 27-In. Built-In Electric Wall Oven70 pg
    Covers this model

Tech Sheet

  • Appliance Diagnostic Modes Range GE Consumer & Industrial Technical Training255 pg
    Covers this model

Training

  • 27-In. Built-In Electric Wall Oven Technical Service Guide70 pg
    Covers this model
  • TECHNICAL SERVICE GUIDE 27-In. Built-In Electric Wall Oven70 pg
    Covers this model
MyPros+ Max

Diagnose your GE JCKP18.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (9)

CodeMeaning
F0Stuck key or shorted keypad detected on the control panel.F2Oven over-temperature condition detected by the control.F3Oven temperature sensor open circuit (open sensor).F4Oven temperature sensor shorted circuit (shorted sensor).F5Sensor circuit supervisor failure in the control board.F7Stuck or shorted function key on the keypad.F8Control board failure (internal ERC fault).F9Door lock/latch motor failureFFLoss of latch motor safety circuit.

Service modes (10)

  • ERC Failure Code RecallPress together
  • J2S968/JGS968/JGSP48 Fault Code Recall["Press TIMER, CLOCK, and MIN DOWN (or 9) key to get Fault Codes to appear."]
  • JB905/968/988 Fault Code Recall["Press TIMER and CLOCK (or 9) key to get Fault Codes to appear."]
  • JP938/JP968 Cooktop Calibration Mode["Clear everything from the top of the glass.","Lock the control by pressing the LOCK key for 3…
  • JP938/JP968 Cooktop Technician Mode["Lock cooktop by holding CONTROL LOCK key for 3 seconds.","Control will beep 2 times and LOCK…
  • LOC REF Procedure (JCK915/JCT915/JK915/JT915/JK955/JT955/ZEK938/ZET958)["Reinitiate LOC REF procedure by pressing BAKE/BROIL simultaneously.","For digital keypads press 9…
  • Microwave Gas Sensor DiagnosticPress and hold the 7 and 8 number pads at the same time
  • Oven Calibration ModePress and hold Bake & Broil pads until SF appears in display. Press Bake pad to enter oven…
  • Special Functions (SF) ModePress and hold BAKE and BROIL pads for 2 seconds
  • Trivection Service Mode["Disconnect main power to the oven for at least 15 seconds.","Reconnect power and enter 0803 on…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass