Model reference
GE JTP13GT1
Oven
5 documents9 error codes9 service modes
Available documentation
Service Manual
- GE 30" Built-In Wall Oven Service Manual34 pg
- 30" Built-In Wall Oven Series Service Manual34 pg
- GE Consumer Service Training Technician Manual GE & Profile 30" Built-in Wall Ovens33 pg
Training
- GE & Profile 30" Built-in Wall Ovens Technician Manual33 pg
- GE Consumer Service Training Technician Manual - GE & Profile 30" Built-in Wall Ovens33 pg
MyPros+ Max
Diagnose your GE JTP13GT1.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (9)
CodeMeaning
F1Stuck key detected on the control key panel.F2Oven over-temperature exceededF3Open oven sensor circuit.F4Shorted oven sensor circuit.F7Stuck key detected on the control key panel (same as F1 range).F8Component failure within ERC affecting temperature processing circuits.F9Problem with door lock circuit.FdShorted meat probe.FFComponent failure within ERC affecting temperature processing circuits.Service modes (9)
- +/- Pad Speed Adjustment (Convection Control)["Press and hold +/- and Timer pads for 2 to 3 seconds.","A number between 1 and 5 will be…
- +/- Pad Speed Change (Convection models)["Press and hold +/- and Timer pads for 2 to 3 seconds.","A number between 1 and 5 will be…
- Bake Temperature Calibration["Press BAKE pad.","Select any temperature above 500°F by pressing the + pad.","Immediately press…
- Child Lockout["Press and hold +/- pads along with STOP TIME pad for approximately 2 seconds.","The word 'OFF'…
- Child Lockout (Convection models)["Press and hold +/- pads along with STOP TIME pad for approximately 2 seconds.","The word 'OFF'…
- Child Lockout (Profile/Convection models)Press and hold +/- pads along with STOP TIME pad for approximately 2 seconds
- End of Cycle Tone Disable/Enable["Press and hold the CLEAR/OFF pad for 10 seconds to eliminate the repeating tone every 6 seconds."]
- End of Cycle Tone EliminationPress and hold the CLEAR/OFF pad for 10 seconds to eliminate the repeating tone every 6 seconds at…
- Increase/Decrease Pad Speed Adjustment (Profile/Convection models)Press and hold +/- and Timer pads for 2 to 3 seconds
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE oven models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass