Model reference
GE MONOGRAM
Oven
10 documents16 error codes11 service modes
Available documentation
Service Manual
- GE and Monogram 27-In. and 30-In. Wall Ovens Technical Service Guide51 pg
- GE and Monogram 27-In. and 30-In. Wall Ovens Technical Service Guide51 pg
- GE Consumer & Industrial Technical Service Guide - Monogram 30-in. Single and Double Convection Wall Ovens53 pg
Training
- GE Consumer Service Training Technician Manual - GE Built-in Wall Ovens52 pg
- GE and Monogram 27-In. and 30-In. Wall Ovens Technical Service Guide51 pg
Other
- 31 9091 ge monogram side by side refrigerator72 pg
- GE Refrigerator Monogram RefrigeratorX SxS41 pg
- GE Refrigerator MONOGRAM ZIS 48D 31 51058 1 mini manual3 pg
- servr man monogram ref ZISS3600MASS32 pg
Quick Reference
- ZET938SM/BM/WM GE Monogram 30" Built-In Single Oven Quick Specs2 pg
MyPros+ Max
Diagnose your GE MONOGRAM.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (16)
CodeMeaning
C1Communication fail with upper relay board.C2Communication fail with upper temperature encoder.C3Communication fail with upper mode encoder.C4Communication fail with lower relay board.C5Communication fail with lower temperature encoder.C6Communication fail with lower mode encoder.F0Shorted OFF key on the key panel.F2Oven temperature inside oven cavity as measured by sensor over 650°F unlatched…F3Open oven sensor (over 2900 ohms).F4Shorted oven sensor (under 950 ohms).F5Sensor circuit supervisor failure.F7Shorted key on logic display assembly.F8EEPROM data shift failure.F9Cooling fan stalls or other cause of open thermal switch (FAD).FCDoor latch error.FFLoss of latch motor (door lock) safety circuit.Service modes (11)
- Control LockoutPush and hold the COOK TIME and DELAY START buttons at the same time for 3 seconds until the…
- F Code Recall ModePress together the TIMER, CLOCK, and ENTER buttons for 3 seconds
- Glass Touch Parameter Reset (Control Panel Opened or Not Operating)1) Press Bake and Broil keys simultaneously
- Glass Touch Parameter Setting (New Part Installation)1) Reassemble control panel and return oven to normal installation
- Oven Calibration ModePress and hold BAKE & BROIL pads until SF appears in display
- Recall Stored F-codesPress TIMER, CLOCK, and MIN DOWN (or 9) together to recall stored fault codes from EEPROM.
- Recall Stored Fault CodesPress TIMER, CLOCK, and MIN DOWN (or 9) together.
- Sales ModeConnect the unit to 120 VAC from L1-L2
- Service Test Mode (Factory Test Mode)1
- Special Features Mode1
- Special Functions (SF) ModePress and hold BAKE and BROIL pads simultaneously for 2 seconds
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE oven models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass