Model reference
GE J2S968
Range
7 documents14 error codes13 service modes
Available documentation
Service Manual
- Owner's Manual - Ranges Self-Cleaning Dual Fuel Convection48 pg
- TECHNICAL SERVICE GUIDE Profile Dual Fuel and Profile All Gas Slide-In Ranges63 pg
- Profile Dual Fuel and Profile All Gas Slide-In Ranges Technical Service Guide63 pg
Tech Sheet
- Appliance Diagnostic Modes Range GE Consumer & Industrial Technical Training255 pg
Bulletin
- Service Bulletin RANGE RA 04-041 pg
- Calibration Error and F0 Display1 pg
- Service Bulletin - Calibration Error and F0 Display1 pg
MyPros+ Max
Diagnose your GE J2S968.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (14)
CodeMeaning
FFunction error code indicated by 'F' followed by a number or letter flashing in…F0Shorted OFF key detected on the control panel.F2Over temperature conditionF3Open oven sensor (under 950 ohms).F4Shorted oven sensor (over 2900 ohms).F5Sensor circuit supervisor failure in the control board.F7Shorted matrix or START key.F8EEPROM data shift failure.F9Cooling fan stalls while above 650°F; open thermal switch in yellow leads.FFLoss of latch motor safety circuit.HOTOven temperature is above 125°F (52°C), preventing proofing mode from operating.LOC ONControl lockout is activated; all touch pads are disabled and will not respond…LOCKEDOven door is locked due to self-clean cycle temperature or the self-clean cycle…PROBEProbe is inserted into the oven outlet but no probe temperature has been set…Service modes (13)
- 12-Hour Shutdown Disable1
- Control LockoutTouch and hold the 9 and 0 pads at the same time for 3 seconds.
- F Code RecallPress TIMER, CLOCK, MIN DOWN (or 9) together to recall stored F codes.
- Fahrenheit or Celsius Temperature Selection1
- Failure Code RecallPress TIMER, CLOCK, and MIN DOWN (or 9) together to recall stored F codes.
- J2S968/JGS968/JGSP48 Fault Code Recall["Press TIMER, CLOCK, and MIN DOWN (or 9) key to get Fault Codes to appear."]
- JB905/968/988 Fault Code Recall["Press TIMER and CLOCK (or 9) key to get Fault Codes to appear."]
- JP938/JP968 Cooktop Calibration Mode["Clear everything from the top of the glass.","Lock the control by pressing the LOCK key for 3…
- JP938/JP968 Cooktop Technician Mode["Lock cooktop by holding CONTROL LOCK key for 3 seconds.","Control will beep 2 times and LOCK…
- LOC REF Procedure (JCK915/JCT915/JK915/JT915/JK955/JT955/ZEK938/ZET958)["Reinitiate LOC REF procedure by pressing BAKE/BROIL simultaneously.","For digital keypads press 9…
- Oven Calibration Mode1
- Special Features Mode (SF)Touch the BROIL HI/LO and BAKE pads at the same time for 3 seconds until the display shows SF.
- Trivection Service Mode["Disconnect main power to the oven for at least 15 seconds.","Reconnect power and enter 0803 on…
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass