Model reference

GE JGSP20

Range

1 document12 error codes2 service modes

Available documentation

Service Manual

GE 30 Inch Slide In Gas Ranges JGSP2065 pg
Covers this model

MyPros+ Max

Diagnose your GE JGSP20.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Range

DOOR on my GE JGSP20

M+

Door not locked for clean cycle, did

From Service Manual 435115, p.47:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part WH44X10288

Door lock assembly

Error codes (12)

CodeMeaning

DOORDoor not locked for clean cycle, did not unlock after clean, door not closed at…F0Failed transistor in control (ERC).F1Failed transistor in control (ERC).F2Oven exceeded 590°F with door unlocked or exceeded 990°F with door locked; also…F3Open sensor or open sensor circuit, or sensor lead shorted to ground, or…F4Shorted sensor or short in sensor harness, or melted sensor connector due to…F5Failed transistor in control (ERC).F6Problem within time keeping circuits due to fluctuation of the 60 Hz power…F7Stuck function switch or button (BAKE, BROIL, CLEAN, etc.) on ERC.F8Component failure detected within ERC affecting temperature processing circuits.F9Problem with door lock circuit such as a pinched wire between ERC and door lock…FFFailed transistor in control (ERC-II); same as F0/F1.

Service modes (2)

Bake Temperature Calibration (ERC-I)1
Bake Temperature Calibration (ERC-II)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass