Model reference
KitchenAid KERC507EAL3
Range
7 documents26 error codes17 service modes
Available documentation
Tech Sheet
- TECH SHEET4 pg
Service Manual
- KitchenAid Electronic Range Controls "B" & "D" Line Wall Ovens Job Aid93 pg
Training
- Failure Codes & Wiring Diagrams for KitchenAid Freestanding & Slide-In Ranges And Built-In Ovens32 pg
Installation Guide
- Instruction Sheet2 pg
- Installation Instructions5 pg
Quick Reference
- Quick Reference Manual2 pg
Other
- 431716993 pg
MyPros+ Max
Diagnose your KitchenAid KERC507EAL3.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (26)
CodeMeaning
F1Control out of calibration.F1 E0EEPROM read fault (silent fault, not displayed).F1 E1EEPROM checksum does not match at start key (silent fault, not displayed).F1 E3Configuration jumper changeF1 E4Q8 shorted.F1 E9Stack overflow, highest priority fault.F2Keyboard shorted or CANCEL not operating.F2 E0Cancel key level too low (open).F2 E2Cancel key loop test failed.F2 E3Key held down too long or keyboard short.F2 E4Keys unsettled, probably due to noise.F3Oven probe shorted or open.F3 E0Oven temperature sensor (PLAT sensor) open.F3 E1Oven temperature sensor (PLAT sensor) shorted.F3 E2Oven temperature too high (runaway).F4Meat probe shorted.F4 E1Meat probe shorted (less than 1500 ohms).F5Door signal inconsistent.F5 E1Self-clean latch will not make after 30 seconds.F5 E3Loss of 120 VAC across L1 to ground, or Q19 circuit error.F5 E5Self-clean temperature not satisfied after 30 minutes.F5 E6Door locked with door open.F5 E7Door unlocked and will not unlatch.F6 E0Ambient sensor opened (too hot).F7 E0Input switches will not follow their strobe level (shorted to ground).PFPower failureService modes (17)
- Bake Temperature Offset AdjustmentPush and hold the BAKE pad for four (4) seconds
- Convection Freestanding/Slide-In Control ProgrammingAfter unit is powered up, press the following keypad sequence
- Hidden Functions - Bake Temperature CalibrationTouch and hold the Bake keypad for 5 seconds.
- Hidden Functions - Clock Display OffTouch and hold the Clock keypad for 5 seconds.
- Hidden Functions - DehydrateTouch and hold the Conv
- Hidden Functions - End-of-Cycle Tones OffTouch and hold the Cook Time keypad for 5 seconds.
- Hidden Functions - Fahrenheit/Celsius ToggleTouch and hold the Broil keypad for 5 seconds.
- Hidden Functions - Keypad Entry Tones OffTouch and hold the Stop Time keypad for 5 seconds.
- Hidden Functions - Keypad LockoutTouch and hold the #3 keypad for 5 seconds.
- Hidden Functions - Last F/E Code and ROM RevisionTouch and hold the #0 keypad for 5 seconds.
- Hidden Functions - Raising Bread DoughTouch and hold the Baked Goods keypad for 5 seconds.
- Hidden Functions - Range Configuration DisplayTouch and hold the #1 keypad for 5 seconds.
- Hidden Functions - Sell ModeTouch and hold the Timer Cancel keypad for 5 seconds.
- Hidden Functions - Timer Operating Tones OffTouch and hold the Timer Start keypad for 5 seconds.
- Hidden Functions - Tone Frequency ChangeTouch and hold the #7 keypad for 5 seconds.
- Non-Convection Freestanding/Slide-In Control ProgrammingAfter unit is powered up, press the following keypad sequence
- Sabbath Mode1
Full entry steps, exit procedures, and test sequences are available in Max.
Related KitchenAid range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass