Model reference

KitchenAid KERC601HWH5

Range

3 documents23 error codes1 service mode

Available documentation

Tech Sheet

Tech Sheet - 97822456 pg
Covers this model

Wiring Diagram

KitchenAid Range KESC307HWH5 Wiring Sheet1 pg
Covers this model

Installation Guide

Installation Instructions5 pg
Covers this model

MyPros+ Max

Diagnose your KitchenAid KERC601HWH5.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·KitchenAid Range

F1E0 on my KitchenAid KERC601HWH5

M+

EEPROM read fault (silent fault, not

From Tech Sheet W10386011, p.23:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (23)

CodeMeaning

F1E0EEPROM read fault (silent fault, not displayed).F1E1EEPROM checksum does not match at start key (silent fault, not displayed).F1E3Configuration jumper change F1E4Q8 shorted.F1E9Stack overflow, highest priority.F2E0Keypad switch assembly misconnected to control.F2E2Cancel key loop test failed.F2E3Key held down too long or keyboard short.F2E4Keys unsettled, probably due to noise.F2E5Cancel key failed.F3E0Oven sensor open.F3E1Oven sensor shorted.F3E2Oven temperature too high (runaway).F4E1Meat probe shorted (less than 1500 ohms).F5E0Door locked somehow with door open.F5E1Self clean latch lock make after 30 seconds.F5E3Loss of 120 VAC across L1 to ground or Q19 circuit error.F5E5Self clean temperature not satisfied after 30 minutes.F5E6Door locked somehow with door open.F5E7Door unlocked somehow and will not unlatch.F6E0Ambient (console bi-metal) sensor opened (too hot).F7E0Input switches won't follow their strobe level (shorted to ground).PFPower failure (not a failure mode).

Service modes (1)

F1E3 Configuration Reset / Timer ID Verification["Make sure harness to P1 connector is correct per wiring diagram.","Step 1

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass