mypros+
Model reference

KitchenAid KERC607HBL6

Range

8 documents23 error codes2 service modes

Available documentation

Tech Sheet

  • wiringsheet-9754373.pdf1 pg
    Covers this model
  • TECH SHEET - 9754365 - Rev A8 pg
    Covers this model
  • Tech Sheet 97543654 pg
    Covers this model
  • TECH SHEET - KitchenAid Range KESH307HBS68 pg
    Covers this model

Wiring Diagram

  • KitchenAid Range KESC307HWH5 Wiring Sheet1 pg
    Covers this model

Service Flash

  • KitchenAid Gas And Electric Freestanding And Slide-In Ranges3 pg
    Covers this model
  • Service Pointer - Error Code F1 E3 appears after servicing the range4 pg
    Covers this model

Installation Guide

  • Installation Instructions12 pg
    Covers this model
MyPros+ Max

Diagnose your KitchenAid KERC607HBL6.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (23)

CodeMeaning
F0 E0No fault found.F1 E2Lost communication with power board.F1 E3Configuration jumper change; freestand, electric switches or P3 pins 1 to 5…F1 E4Oven sensor not calibrated.F1 E5Meat probe not calibrated.F1 E6Display board EPROM access failure.F1 E7Power board EPROM access failure.F1 E8Improper keypad feedback from power board supply lift.F1 E9Unstable keyboard gain.F1 EAExceeded stack warning level.F2 E0User is cleaning too long or keypad is disconnected.F2 E1Cancel key invalid.F2 E3Key held down too long or keyboard short or spill on switch surface.F3 E0Oven sensor open circuit.F3 E3Shorted oven sensor.F3 E4Oven temperature too high (runaway condition).F4 E0Meat probe shorted (less than 1500 ohms).F5 E1Self clean latch not locking.F5 E5Self clean temperature not achieved after 30 minutes.F5 E7Door unlocked but will not unlatch during clean cycle.F7 E0Invalid latch switch reading.F7 E1Invalid door switch reading.PFPower failure occurred (not a failure mode).

Service modes (2)

  • End of Service Test Sequence (Convection Units)["Connect unit to power, set power ON and wait until CONTROL LOCK clears and display shows PF…
  • End of Service Test Sequence (Non-Convection Units)["Connect unit to power, set power ON and wait until CONTROL LOCK clears and display shows PF…

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass