Model reference

KitchenAid KGRT500FAL2

Range

3 documents21 error codes2 service modes

Available documentation

Tech Sheet

TECH SHEET - KitchenAid Range KGST307BBL28 pg
Covers this model
TECH SHEET8 pg
Covers this model

Other

431716993 pg
Covers this model

MyPros+ Max

Diagnose your KitchenAid KGRT500FAL2.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·KitchenAid Range

F1E0 on my KitchenAid KGRT500FAL2

M+

EEPROM read fault (silent fault, not

From Tech Sheet W12051093, p.25:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (21)

CodeMeaning

F1E0EEPROM read fault (silent fault, not displayed).F1E1EEPROM checksum does not match at start key (silent fault, not displayed).F1E3Configuration jumper change; freestanding, electric switches or P9 pins 6 to 7…F1E4Q8 shorted.F1E9Stack overflow, highest priority.F2E0Cancel key level too low (open).F2E2Cancel key loop test failed.F2E3Key held down too long or keyboard short.F2E4Keys unsettled probably due to noise.F3E0Oven sensor open.F3E1Shorted oven sensor.F3E2Oven temp too high (runaway).F4E1Meat probe shorted (less than 1500 ohms).F5E1Self clean latch lock make after 30 seconds.F5E3Loss of 120 VAC across L1 to Ground or Q19 circuit error.F5E5Self clean temperature not satisfied after 30 minutes.F5E6Door locked somehow with door open.F5E7Door unlocked somehow and will not unlatch.F6E0Ambient (console bi-metal) sensor opened (too hot).F7E0Input switches won't follow their strobe level (shorted to ground).PFPower failure indication (not a failure mode).

Service modes (2)

F1E3 Configuration Reconfiguration ProcedureStep 1: Make sure harness to P1 connector is correct per wiring diagram. Step 2: Power down and…
F1E3 Configuration Reset["Verify harness to P1 connector is correct per wiring diagram.","STEP 1

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass