mypros+
Model reference

Maytag AGR5712ADS

Range

9 documents36 error codes52 service modes

Available documentation

Tech Sheet

  • Cuisinière autoportante au gaz — Informations techniques10 pg
    Covers this model
  • Tech Sheet - 16023524F (FR)10 pg
    Covers this model

Service Manual

  • Service Manual - Freestanding Gas Range63 pg
    Covers this model
  • Freestanding Gas Range Service Manual63 pg
    Covers this model
  • Maytag Heritage Wiring Diagrams _ Fault Codes MC 1124 pg
    Covers this model
  • FAILURE CODES AND WIRING DIAGRAMS for MAYTAG HERITAGE GAS & ELECTRIC RANGES124 pg
    Covers this model

Bulletin

  • Installation Bulletin - IDC-011-B Gas Conversion1 pg
    Covers this model
  • Installation Bulletin - IDC-0011-B-French Gas Conversion1 pg
    Covers this model
  • Technical Bulletin - TDC-0086-B-French Clock fails or fades out when using bake or broil function1 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag AGR5712ADS.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (36)

CodeMeaning
1c1cShorted key detected on the control board.1c2cKeyboard tail disconnected; keyboard loop reading improper value.1c31Cancel key circuit problem; cancel key reading improper value.1c32Cancel key circuit problem (cancel key improper value) on lower oven cavity.1c4cPower micro communication failure (CRC invalid).1c6cEEPROM error; no response from EEPROM after 3 tries.1c7cControl not calibrated; calibration value out of range.1c81Cook profile corrupted in EEPROM for upper/single oven cavity (CRC invalid).1c82Cook profile corrupted in EEPROM for lower oven cavity (CRC invalid).1c8cCooking program error; CRC invalid when cook or clean is programmed.1d11Runaway temperature (650°F) detected with door unlocked; sensor resistance…1d12Runaway temperature (650°F) detected with door unlocked on lower oven cavity.1d21Runaway temperature (950°F) detected with door locked; sensor resistance…1d22Runaway temperature (950°F) detected with door locked on lower oven cavity.3d11Temperature sensor open; sensor resistance reads infinite ohms during cook or…3d12Temperature sensor failure (open) on lower oven cavity3d21Temperature sensor shorted; sensor resistance reads 0 ohms during cook or clean.3d22Temperature sensor failure (short) on lower oven cavity3d41Meat probe shorted3d51Meat probe not calibrated4d11Door switch not closed when door is locked.4d12Door switch position failure4d21No Reverse Airflow Fan rotation (no/low RPM) on upper/single oven cavity.4d22No Reverse Airflow Fan rotation (no/low RPM) on lower oven cavity.4d31Reverse Airflow Fan state error4d32Reverse Airflow Fan state error4d41High Reverse Airflow Fan rotation (high RPM) on upper/single oven cavity.4d42High Reverse Airflow Fan rotation (high RPM) on lower oven cavity.4d51Door switch not reading open or closed (invalid state).4d52Door switch circuit failure
View all 36 error codes
9d11Door latch will not lock; lock switch not closed when it should be locked.9d12Door latch will not lock on lower oven cavity9d21Door latch will not unlock on upper/single oven cavity9d22Door latch will not unlock on lower oven cavity9d31Door latch both locked and unlocked simultaneously on upper/single oven9d32Door latch both locked and unlocked simultaneously on lower oven

Service modes (52)

  • 12/24 Hour Clock["Press and hold CANCEL and DELAY keys simultaneously for 3 to 5 seconds.","Press MORE+ or LESS- to…
  • 24 Hour Clock Toggle["Press and hold Cancel and Delay pads for 3 to 5 seconds.","Press More (+) or Less (-) pads to…
  • 24-Hour Clock TogglePress and hold CANCEL and DELAY keys simultaneously for 3 to 5 seconds. Press MORE + or LESS
  • Child Lock Out["Press and hold Cancel and Cook & Hold pads for 3 to 5 seconds until beep sounds."]
  • Child Safety LockPress and hold CANCEL and COOK & HOLD keys simultaneously for 3 to 5 seconds until a beep sounds.
  • Clock Display On/Off["Press and hold CANCEL and CLOCK keys simultaneously for 3 to 5 seconds."]
  • Clock Display TogglePress and hold CANCEL and CLOCK keys simultaneously for 3 to 5 seconds to toggle time display…
  • Clock Display Toggle (On/Off)["Press and hold Cancel and Clock pads for 3 to 5 seconds."]
  • Default Configuration Reset["Press and hold CANCEL and KEEP WARM keys simultaneously for 3 to 5 seconds."]
  • Diagnostic Code Display["Must be started within 60 seconds of powering up the control.","Press and hold More (+) pad…
  • Diagnostic Code Display Mode["Must be started within 60 seconds of powering up the control.","Press and hold More + pad within…
  • Diagnostic Code Display Mode (H1 Controls)Press and hold AUTOSET pad for 3 seconds at power-up.
  • Diagnostic Code Display Mode (H1)Press and hold the Autoset pad for 3 seconds at power-up.
  • Diagnostic Code Display Mode (H2.5)Press and hold Upper Cancel and Autoset pads for 3 seconds
  • Diagnostic Code Display Mode (H3 Controls)Press and hold Upper Cancel and Timer for 3 to 5 seconds within 5 minutes of power up.
  • Diagnostic Code Display Mode (H3)Press and hold Upper Cancel and Timer for 3 to 5 seconds within 5 minutes of power up
  • Diagnostic Code Display Mode (M1/M2)Diagnostic Code Display Mode can only be started within 30 seconds when powering up the control.
  • Diagnostic Code Display Mode (NSC Controls)Press and hold the More + pad for 3 to 5 seconds when powering up the unit (within 60 seconds of…
  • Diagnostic Code Display Mode (NSC)Press and hold More + pad for 3 to 5 seconds within 60 seconds of powering up the unit. Cycle…
  • Factory Default Reset["Press and hold Cancel and Keep Warm pads for 3 to 5 seconds until beep sounds."]
  • Faults Access (EOC III Controls)1
  • Faults Access (EOC III)1
  • One-Watt Standby Mode (NSC Controls)Press and hold Cancel and Less
  • One-Watt Standby Mode (NSC)Press and hold Cancel and Less
  • Oven Temperature Adjustment["Press Bake pad.","Enter 550 on the digit-pad.","Immediately press and hold Bake pad for 3 to 5…
  • Oven Temperature Calibration["Press the BAKE key.","Use the numeric keypad to enter 550.","Immediately press and hold the BAKE…
  • Quick Test Mode["Must be entered within the first 5 minutes after power up.","Press and hold Cancel and Broil pads…
  • Quick Test Mode (EOC III Controls)1
  • Quick Test Mode (EOC III)1
  • Quick Test Mode (Factory Test Mode)["Press and hold CANCEL and BROIL keys simultaneously for 3 seconds.","Release both keys once the…
  • Quick Test Mode (H1 Controls - Convection Model)1
  • Quick Test Mode (H1 Controls - Non-Convection Model)1
  • Quick Test Mode (H1 Convection Model)1. Press and hold Cancel and Broil pads for 3 seconds. 2. Release both pads. 3. Press pads
  • Quick Test Mode (H1 Non-Convection Model)1. Press and hold Cancel and Toast pads for 3 seconds. 2. Release both pads. 3. Press pads
  • Quick Test Mode (H2/H2.5 Control)1. Press and hold Cancel and Broil pads for 3 to 5 seconds. 2. Release both pads. 3. Press pads
  • Quick Test Mode (H2/H2.5 Controls)1
  • Quick Test Mode (H3 Control)1. Press and hold Upper Cancel and Broil pads for 3 seconds. 2. Release both pads. 3. Press pads
  • Quick Test Mode (H3 Controls)1
  • Quick Test Mode (M1/M2 Control)1. Press and hold Cancel and Broil pads for 3 seconds. 2. Release both pads. 3. Press pads
  • Quick Test Mode (M1/M2 Controls)1
  • Quick Test Mode (NSC Non-Self Clean Controls)1
  • Quick Test Mode (NSC Non-Self Cleaning Control)1. Press and hold Cancel and Broil pads for 3 to 5 seconds within 5 minutes of power-up. 2. Release…
  • Sabbath Mode["Desired bake function must be initiated before entering Sabbath mode.","Hold Clock pad for 3 to 5…
  • Service Mode (EOC III Controls)1
  • Service Mode (EOC III)1
  • Temperature Display (°F/°C toggle)["Press and hold Cancel and Bake pads for 3 to 5 seconds.","Press More (+) or Less (-) pads to…
  • Temperature Display (C/F toggle)Press and hold CANCEL and BAKE keys simultaneously for 3 to 5 seconds. Press MORE + or LESS
  • Temperature Display (Celsius/Fahrenheit)["Press and hold CANCEL and BAKE keys simultaneously for 3 to 5 seconds.","Press MORE+ or LESS- to…
  • Temperature Display Toggle (°F/°C)["Press and hold Cancel and Bake pads for 3 to 5 seconds.","Press More + or Less
  • Test Mode (UH Control)1
  • Test Mode (UH Controls)1
  • Twelve Hour Shutoff

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag range models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass