Model reference
Maytag AGS5830BD
Range
7 documents27 error codes15 service modes
Available documentation
Service Manual
- Gas Slide-In Range Service Manual55 pg
Tech Sheet
- Tech Sheet - 1602629110 pg
Installation Guide
- Installation Bulletin - IDC-0013-B Filler Kit2 pg
- Bulletin d'installation - Trousse de panneau latéral IDC-0014-B-F2 pg
- Installation Bulletin - IDC-0014-B Side Panel Kit2 pg
- Installation Bulletin - Slide-In Ranges Side Panel Kit Installation Instructions2 pg
Other
- TDC 0099 B1 pg
MyPros+ Max
Diagnose your Maytag AGS5830BD.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (27)
CodeMeaning
1c1cShorted key detected on control circuit board.1c2cKeyboard tail disconnected; keyboard loop improper value.1c31Cancel key circuit problem; cancel key improper value.1c32Cancel key circuit problem; cancel key improper value.1c6cEEPROM error; no response from EEPROM after 3 tries.1c7cControl not calibrated; calibration value out of range.1c8cCooking program error; CRC invalid.1d11Runaway temperature (650°F) detected, door unlocked; sensor resistance > 2237…1d12Runaway temperature (650°F) detected, door unlocked; sensor resistance > 2237…1d21Runaway temperature (950°F) detected, door locked; sensor resistance > 2787…1d22Runaway temperature (950°F) detected, door locked; sensor resistance > 2787…3d11Temperature sensor open; sensor resistance reads infinite Ohms.3d12Temperature sensor open; sensor resistance reads infinite Ohms.3d21Temperature sensor shorted; sensor resistance reads 0 Ohms.3d22Temperature sensor shorted; sensor resistance reads 0 Ohms.4d11Door switch position failure; door switch not closed when door is locked.4d12Door switch position failure; door switch not closed when door is locked.4d21No reverse airflow fan rotation (no or low RPM).4d31Reverse airflow fan state error (on when it should be off).4d51Door switch circuit failure; door switch not open or closed.4d52Door switch circuit failure; door switch not open or closed.9d11Latch will not lock; lock switch not closed.9d12Latch will not lock; lock switch not closed.9d21Latch will not unlock; unlock switch not closed.9d22Latch will not unlock; unlock switch not closed.9d31Latch state unknown; both locked and unlocked switches indicate active…9d32Latch state unknown; both locked and unlocked switches indicate active…Service modes (15)
- 24-Hour Clock TogglePress Cancel and Favorite pads simultaneously for 5 seconds.
- Clock Display Disable/EnablePress and hold Cancel and Clock pads simultaneously for 5 seconds.
- Control LockPress Cancel and Cook & Hold pads simultaneously for 5 seconds to enable.
- Diagnostic Code DisplayPress and hold the Autoset 0 pad for 5 seconds while powering up the unit
- Factory Default ResetPress and hold Cancel and Keep Warm pads simultaneously for 5 seconds.
- H1 Diagnostic Code DisplayPress and hold Autoset 0 pad and power up the unit
- H1 Quick Test Mode1. Press and hold Cancel and Broil pads for 5 seconds at power-up or within 5 minutes of power-up…
- M1 Diagnostic Code DisplayPress and hold Up Arrow pad within 60 seconds of powering up the unit
- M1 Quick Test Mode1. Press and hold CANCEL and BROIL pads for 5 seconds (must be within first 5 minutes of power up)…
- M2 Diagnostic Code DisplayPress and hold Autoset pad for 5 seconds at power-up
- M2 Quick Test Mode1. Press and hold CANCEL and BROIL pads for 5 seconds. 2. Once entered, release both pads. 3. Press…
- Oven Temperature AdjustmentPress Bake pad and enter 550°F
- Quick TestPress and hold the Cancel and Broil pads simultaneously for 5 seconds at power-up, or within 5…
- Temperature Display Toggle (°F/°C)Press and hold Cancel and Bake pads simultaneously for 5 seconds.
- Twelve Hour Off / Sabbath ModePress and hold Clock pad for 5 seconds.
Full entry steps, exit procedures, and test sequences are available in Max.
Related Maytag range models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass