Model reference
Maytag JDS8850AA*
Range
1 document18 error codes3 service modes
Available documentation
Tech Sheet
- Technical Information⎯Dual Fuel Slide-In Range15 pg
MyPros+ Max
Diagnose your Maytag JDS8850AA*.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (18)
CodeMeaning
F0-0No fault present.F1-1Oven temperature above 650°F (343°C) in bake mode.F1-3Oven temperature above 950°F (510°C) during a clean cycle.F1-5Cancel pad not responding.F1-7Membrane disconnected.F1-8Shorted key (pad) in membrane switch.F1-9Internal control communication errors.F1-ALock/unlock switch state not advancing to control.F1-COven door switch state not advancing to control.F1-EControl not calibrated.F1-FJumper not removed from printed circuit board (PCB).F1-HEEPROM error.F1-NInternal voltage for slave micro incorrect.F3-1Open or shorted oven temperature sensor.F8Shorted meat probe.F9-1Oven door will not lock.F9-2Oven door will not unlock.F9-3Oven door status is both locked and unlocked.Service modes (3)
- Oven Temperature AdjustmentPress Bake pad and enter 550°F (288°C)
- Quick Test ModePress and hold Cancel and Broil pads simultaneously for 3 seconds at power-up, or within 5 minutes…
- Setup Options (Factory Default Options)Press Setup Options and the desired pad simultaneously (see table for specific pad combinations)
Full entry steps, exit procedures, and test sequences are available in Max.
Related Maytag range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass