Model reference
Maytag MES5552BA*
Range
4 documents27 error codes19 service modes
Available documentation
Tech Sheet
- Electric Slide-In Range⎯Technical Information10 pg
Service Manual
- Service Manual - 16026299_1602629945 pg
Service Flash
- Technical Bulletin - TDC-0096-B Oven Door Handles Breaking_TDC-0096-B2 pg
Other
- TDC 0096 B2 pg
MyPros+ Max
Diagnose your Maytag MES5552BA*.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (27)
CodeMeaning
1c1cShorted key detected; a keypress is stuck or shorted on the control board.1c2cKeyboard tail disconnected; keyboard loop reads an improper value.1c31Cancel key circuit problem; cancel key reads an improper value.1c32Cancel key circuit problem (H1 control only).1c6cEEPROM error; no response from EEPROM after 3 tries.1c7cControl not calibrated; calibration value is out of range.1c8cCooking program error; CRC invalid when cook or clean is programmed.1d11Runaway oven temperature (650°F) detected with door unlocked; sensor resistance…1d12Runaway oven temperature (650°F) with door unlocked (H1 control, second cavity).1d21Runaway oven temperature (950°F) detected with door locked; sensor resistance…1d22Runaway oven temperature (950°F) with door locked (H1 control, second cavity).3d11Temperature sensor open; sensor resistance reads infinite (open circuit).3d12Temperature sensor open (H1 control, second cavity).3d21Temperature sensor shorted; sensor resistance reads 0 Ohms.3d22Temperature sensor shorted (H1 control, second cavity).4d11Door switch not closed when door is locked.4d12Door switch position failure (H1 control, second cavity).4d21No reverse airflow fan rotation detected (no or low RPM)4d31Reverse airflow fan is on when it should be off4d51Door switch not reading open or closed (invalid state).4d52Door switch circuit failure (H1 control, second cavity).9d11Latch will not lock; lock switch not closed when it should be locked.9d12Door latch will not lock (H1 control, second cavity).9d21Door latch will not unlock9d22Door latch will not unlock (H1 control, second cavity).9d31Latch state unknown9d32Latch state unknownService modes (19)
- 24 Hour Clock TogglePress and hold Cancel and Delay pads for 3 to 5 seconds
- Child LockoutPress and hold Cancel and Cook & Hold pads for 3 to 5 seconds until beep sounds.
- Clock Display TogglePress and hold Cancel and Clock pads for 3 to 5 seconds.
- Diagnostic Code DisplayWithin 60 seconds of powering up the unit, press and hold the (slew up) pad
- Factory Default ResetPress and hold Cancel and Keep Warm pads for 3 to 5 seconds until beep sounds.
- H1 Diagnostic Code Display["Press and hold the AUTOSET pad for 3 to 5 seconds at power-up.","Can only be started while…
- H1 Quick Test Mode["Press and hold Cancel and Broil pads for 3 to 5 seconds.","Once the control enters Quick Test…
- M1 Child Lockout["Press and hold Cancel and Cook & Hold pads for 3 to 5 seconds until beep sounds."]
- M1 Diagnostic Code Display["Must be started within 60 seconds of powering up the control.","Press and hold the slew up…
- M1 Factory Default Reset["Press and hold Cancel and Keep Warm pads for 3 to 5 seconds until beep sounds."]
- M1 Oven Temperature Adjustment["Press Bake pad.","Enter 550 on the digit-pad.","Immediately press and hold Bake pad for 3 to 5…
- M1 Quick Test Mode["Must be entered within the first 5 minutes after power up.","Temperature sensor must be below…
- M1 Sabbath Mode["Initiate desired bake function first.","Hold Clock button for 3 to 5 seconds to activate Sabbath…
- M2 Diagnostic Code Display["Press and hold the AUTOSET pad for 3 to 5 seconds at power-up.","Can only be started while…
- M2 Quick Test Mode["Must be entered within the first 5 minutes after power up.","Temperature sensor must be below…
- Oven Temperature Adjustment1
- Quick Test1. Press and hold Cancel and Broil pads for 3 to 5 seconds. 2. Once control has entered Quick Test…
- Sabbath Mode1
- Temperature Display (°F/°C)Press and hold Cancel and Bake pads for 3 to 5 seconds
Full entry steps, exit procedures, and test sequences are available in Max.
Related Maytag range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass