mypros+
Model reference

Maytag MHW6000AG0

Washer

9 documents21 error codes5 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10441081 - Rev C_W1044108144 pg
    Covers this model

Service Flash

  • Technical Service Pointer - W10600534 (Dispenser Drawer)3 pg
    Covers this model
  • TECHNICAL SERVICE POINTER - Front-Load, Direct Drive Washers (ALPHA) Potential Internal Hose Leak3 pg
    Covers this model
  • TECHNICAL SERVICE POINTER - Whirlpool and Maytag Direct Drive Front Load Washers Intermittent Door Lock Operation2 pg
    Covers this model
  • Technical Service Pointer - Drain Pump Assembly Relocation6 pg
    Covers this model
  • Service Pointer - W10611623 - Drain Hose Installation6 pg
    Covers this model

Training

  • Training Pointer W10642118 Changes in Hardware and Diagnostics21 pg
    Covers this model

Installation Guide

  • Instrucciones de instalacion12 pg
    Covers this model
  • Installation Instructions20 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MHW6000AG0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (21)

CodeMeaning
F1E1CCU errorF1E2MCU errorF2E3Unsupported cycleF3E1Pressure system errorF3E2Temperature system errorF4E0Heater is not detectedF5E1Door switch errorF5E2Door lock errorF5E3Door unlock errorF6E1Communication error between CCU and MCUF6E2Communication error UI to CCUF6E3Communication error CCU to UIF7E1Drive motor speed sensing error / washer overloadF7E2MCU overheat and/or motor overheatF8E0Steam inlet valve errorF8E1No water detected entering washer or pressure sensor trip not detectedF8E3Overflow conditionF9E1Long drainrLLoad detected during the washer cleaning cycle (remove load); saved as F0E1.SdSuds detected (alternate display)SudSuds detected

Service modes (5)

  • Fault/Error Code Display["Activate Service Diagnostic Mode first.","Press and release the 3rd button used to activate…
  • Quick Diagnostic Test["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 30 seconds after…
  • Software Version Display["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…
  • User Interface Test["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass