Model reference
Samsung DV393GTPARA/A1-01
Dryer
1 document10 error codes7 service modes
Available documentation
Tech Sheet
- CLOTHES DRYER Technical Information36 pg
MyPros+ Max
Diagnose your Samsung DV393GTPARA/A1-01.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (10)
CodeMeaning
2EElectronic control problem (over voltage error).AEElectronic control problem (communication error).AE3DR Ready Modem Wire Test failure.bE2Invalid state of key circuit short for 30 seconds.dERunning the dryer with door open.dFInvalid door state for more than 256 milliseconds.EtInvalid state of EEPROM communication.FEInvalid power source frequency.HEInvalid heating temperature in running the dryer.tEThe thermistor resistance is very low or high.Service modes (7)
- Continuous Run ModeFrom Power On state (normal user mode), press Mixed Load Bell + Dry Level (DV405, DV395, DV393) or…
- Cycle Count ModeWhile in Service Mode, press Mixed Load Bell (DV405, DV395, DV393) or Time (DV231, DV365) key.
- Data Display ModeWith Power On, press AdjustUp Key + AdjustDown Key for 7 seconds until a beeping sound is heard…
- DR Ready Modem Wire TestAfter entering Service Mode, press the Wrinkle Prevent button to start the Wire Test
- Service ModePress Mixed Load Bell + Temp keys for 3 seconds in normal mode until a beeping sound is heard. For…
- Software Revision ModeWhile in Service Mode, press Temp until a beeping sound is heard. Example
- Touch Sensor Data Display ModeThis is the default mode upon entering Service Mode
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung dryer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax