Model reference
Samsung DV400
Dryer
8 documents11 error codes13 service modes
Available documentation
Service Manual
- Gas and Electric Dryer user manual120 pg
- LG Samsung DV456EWHDWR 4 Troubleshooting12 pg
- CLOTHES DRYER Technical Information40 pg
- Clothes Dryer Service Manual50 pg
Tech Sheet
- CLOTHES DRYER Technical Information24 pg
- CLOTHES DRYER Technical Information12 pg
- LG Samsung DV456EWHDWR 2 product spec4 pg
- LG Samsung DV410AEW Product Specification4 pg
MyPros+ Max
Diagnose your Samsung DV400.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (11)
CodeMeaning
2EElectronic control problem (over voltage error).AEElectronic control communication error between PCBs.AE3DR Ready Modem wire test failure.bEInvalid state of key circuit short for 30 seconds (DV422, DV400 models).bE2Invalid state of key circuit short for 30 seconds.dERunning the dryer with the door open.dFInvalid door state for more than 256 milliseconds.EtInvalid state of EEPROM communication.FEInvalid power source frequency detected.HEInvalid heating temperature detected while running the dryer.tEThe thermistor resistance is very low or high.Service modes (13)
- Continuous Run Mode1
- Cycle Count ModeEnter Service Mode first, then press the Wrinkle Prevent key.
- Data Display ModeWith Power On, press AdjustUp + AdjustDown keys simultaneously for 7 seconds until a beeping sound…
- DR Ready Modem Wire Test1
- Sensor Bar Touch Data ModeWith Power On, press Wrinkle Prevent and Temp keys for 3 seconds
- Service Mode1
- Service Mode (Sensor Bar Touch Data Mode - Default)1
- Smart Care["Press the Power button to turn the dryer on.","Press and hold the Mixed Load Bell button for 3…
- Software Revision ModeWhile in Service Mode, press Temp until a beeping sound is heard
- Software Version ModeEnter Service Mode first, then press Temp key until it sends out a beeping sound.
- System Check ModeWhile in Power Off, press the Dry Level + Power keys simultaneously.
- System Check Mode (t2 mode)1. With dryer powered off, press Dry Level + Power keys simultaneously. 2. Display shows 't2'. 3…
- Touch Sensor Data Display ModeWith power on, press Mixed Load Bell + Temp (DV405, DV398, DV395, DV393) or Wrinkle Prevent + Temp…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung dryer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax