Model reference
Samsung DV45H6300GW
Dryer
2 documents8 error codes7 service modes
Available documentation
Service Manual
- H6000 PJT(DRYER) Repair Manual86 pg
Training
- Training Manual60 pg
MyPros+ Max
Diagnose your Samsung DV45H6300GW.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (8)
CodeMeaning
AEElectronic control communication error between PCBs.bE2Invalid state of key circuit short for 30 seconds.dERunning the dryer with the door open.dFInvalid door state detected for more than 256 milliseconds.EtInvalid state of EEPROM communication.FEInvalid power source frequency detected.HEInvalid heating temperature detected while running the dryer.tEThe thermistor resistance is very low or high.Service modes (7)
- Continuous Run ModeWith power on in normal user mode, press Mixed Load Bell + Dry Level for 7 seconds.
- Cycle Count ModeWhile in Service Mode, press the Mixed Load Bell key.
- Data Display ModeWith power on, press Adjust Up Key + Adjust Down Key for 7 seconds until a beeping sound is heard.
- Service ModeWith power on, press Mixed Load Bell + Temp keys simultaneously for 3 seconds in normal mode until…
- Smart CarePress and hold Eco Dry (Electric model) or Small Load Care (Gas model) button for 3 seconds when an…
- Software Revision ModeWhile in Service Mode, press Temp until a beeping sound is heard.
- Touch Sensor Data Display ModeDefault mode upon entering Service Mode (press Mixed Load Bell + Temp for 3 seconds with power on).
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung dryer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax