Model reference
Samsung DV5451AEW/XAA
Dryer
9 documents13 error codes13 service modes
Available documentation
Tech Sheet
- Fast Track Troubleshooting7 pg
Service Manual
- CLOTHES DRYER SERVICE Manual130 pg
- Service Clothes Dryer130 pg
- Samsung Dryer DV5451 DV5471 DV448AEP Service Manual66 pg
Bulletin
- SERVICE BULLETIN - During a timed drying sequence the timer stops, but the dryer continues operating1 pg
- Door switch change1 pg
- SERVICE BULLETIN - Door switch change1 pg
Quick Reference
- Fast Track Troubleshooting7 pg
Other
- Orca Dryer SVC Manual130 pg
MyPros+ Max
Diagnose your Samsung DV5451AEW/XAA.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (13)
CodeMeaning
bEButton errorbE2Unit detects a button is being pressed for over 30 seconds or a button is stuck.dEDoor is not closing properly; dryer running with door open.dFDoor is not closing properly; dryer running with door open.dO dEDoor openEEprom FailInvalid state of EEPROM communication.EtCheck the heater thermistor; for gas models, check that gas is supplied…FEInvalid power source frequency detected.hEEEPROM is not communicating properly.odOver drytEInvalid heating temperature detected, possibly caused by clogged lint screen or…tODryer thermistor open sensedtSDryer thermistor short sensedService modes (13)
- Continuous Run Mode1
- Cycle Count ModeWhile in Service Mode, press the Wrinkle Prevent button.
- Cycle Count Test ModeWhile in Service Mode, press the Wrinkle Prevent button.
- Data Display ModeWith Power On, press and hold AdjustUp + AdjustDown keys for 7 seconds until a beeping sound is…
- Sensor Bar Touch Data ModeWith Power On, press and hold Wrinkle Prevent and Temp keys for 3 seconds
- Service Mode1
- Service Mode (Sensor Bar Touch Data - Default)1
- Service Mode (Sensor Bar Touch Test — default)With the power on, press Wrinkle Prevent and Temp keys simultaneously for 3 seconds until a beeping…
- Software Version ModeWhile in Service Mode, press Temp until a beeping sound is heard. Example
- Software Version Test ModeWhile in Service Mode, press Temp button until the control beeps
- Special Test Mode (System Check Mode)Press Power button and Dry Level buttons simultaneously. Display will show 't2'. Press Start/Pause…
- System Check Mode (t2 mode)While in Power Off, press and hold Dry Level + Power keys simultaneously. Display shows 't2'…
- Temperature Test Diagnostic ModePress Adjust Time Up + Down keys simultaneously for 7 seconds during Power On state
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung dryer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax