mypros+
Model reference

Samsung DV5471AEPXAC

Dryer

3 documents13 error codes13 service modes

Available documentation

Service Manual

  • Samsung Dryer DV5471 Fast Trac Manual V17 pg
    Covers this model
  • Service Clothes Dryer130 pg
    Covers this model
  • Samsung Dryer DV5451 DV5471 DV448AEP Service Manual66 pg
    Covers this model
MyPros+ Max

Diagnose your Samsung DV5471AEPXAC.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (13)

CodeMeaning
bEButton error; PCB key closed for 75 seconds.bE2Unit detects a button is being pressed for over 30 seconds or a button is stuck.dEDoor is not closing properly; dryer running with door open.dFDoor is not closing properly; dryer running with door open.dODoor open; dryer is running with the door open.EEpromEEPROM fail; invalid state of EEPROM communication.EtCheck the heater thermistor; for gas models, check that gas is supplied…FEInvalid power source frequency detected.hEEEPROM is not communicating properly.odOver dry; invalid/excessive dry time detected.tEInvalid heating temperature detected, possibly caused by clogged lint screen or…tODryer thermistor open sensed; the thermistor resistance is very high.tSDryer thermistor short sensed; the thermistor resistance is very low.

Service modes (13)

  • Continuous Run Mode1
  • Cycle Count ModeWhile in Service Mode, press the Wrinkle Prevent button.
  • Cycle Count Test Mode["Enter Service Mode first (press Wrinkle Prevent and Temp keys for 3 seconds).","Press Wrinkle…
  • Data Display ModeWith Power On, press and hold AdjustUp + AdjustDown keys for 7 seconds until a beeping sound is…
  • Sensor Bar Touch Data ModeWith Power On, press and hold Wrinkle Prevent and Temp keys for 3 seconds
  • Sensor Bar Touch Test["With power on, press Wrinkle Prevent and Temp keys for 3 seconds.","Dryer enters sensor bar touch…
  • Service Mode1
  • Service Mode (Sensor Bar Touch Data - Default)1
  • Software Version ModeWhile in Service Mode, press Temp until a beeping sound is heard. Example
  • Software Version Test Mode["Press Temp button until the control beeps.","Display shows version (e.g., 'U105' where U0 = major…
  • System Check Mode (Special Test Mode)["Press the Power button and Dry Level buttons simultaneously.","Display will show 't2'.","Press…
  • System Check Mode (t2 mode)While in Power Off, press and hold Dry Level + Power keys simultaneously. Display shows 't2'…
  • Temperature Test Diagnostic Mode["Press Adjust Time Up + Down keys for 7 seconds during Power On state.","Press Adjust Time Up to…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung dryer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax