Model reference

Thermador X302XB

Oven

1 document16 error codes3 service modes

Available documentation

Service Manual

Care & Use Manual for Thermador Built-In Ovens40 pg
Covers this model

MyPros+ Max

Diagnose your Thermador X302XB.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Thermador Oven

dor on my Thermador X302XB

M+

Reminder that the oven door must be

From Service Manual 878889, p.21:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part 00630783

Door lock assembly

Error codes (16)

CodeMeaning

dorReminder that the oven door must be closed before the Self Clean mode can be…ErrDisplays if an invalid temperature or time is entered.F-Electronic control board fault code indicating a problem with the signal sent…F-1Electronic control board fault code indicating a problem with the signal sent…F-2Electronic control board fault code indicating a problem with the signal sent…F-3Electronic control board fault code indicating a problem with the signal sent…F-4Electronic control board fault code indicating a problem with the signal sent…F-5Electronic control board fault code indicating a problem with the signal sent…F-6Electronic control board fault code indicating a problem with the signal sent…F-7Caused by close contact to the control panel for more than 32 seconds, such as…F-8Electronic control board fault code indicating a problem with the signal sent…F-9Electronic control board fault code indicating a problem with the signal sent…FCElectronic control board fault code indicating a problem with the signal sent…FFElectronic control board fault code indicating a problem with the signal sent…FrElectronic control board fault code indicating a problem with the signal sent…SAbIndicates the oven is in Sabbath mode.

Service modes (3)

Change to 24-Hour Clock["Turn off all ovens.","Touch and hold the UPPER pad (double oven) or the OFF pad (single oven)…
Change to Centigrade Temperature["Turn off all ovens.","Touch and hold the UPPER or the OFF pad and then touch the CONVECTION…
Oven Temperature Calibration["Turn off all ovens.","Touch and hold the UPPER pad (double oven) or the OFF pad (single…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Thermador oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass