Model reference

Whirlpool W10110637

Dryer

3 documents25 error codes7 service modes

Available documentation

Tech Sheet

Tech Sheet - do not Discard12 pg
Covers this model
TECH SHEET - Kenmore Whirlpool Dryer 110 8709160112 pg
Covers this model
TECH SHEET - Kenmore Whirlpool Dryer 110 9708160112 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10110637.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dryer

AF on my Whirlpool W10110637

M+

Low inlet air flow detected at

From Tech Sheet W17516978, p.30:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

AFLow inlet air flow detected at installation.F:01Primary control failure.F:02Stuck button or user interface mismatch (only appears in diagnostic test mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:24Inlet thermistor is open (only appears in diagnostic test mode).F:25Inlet thermistor is shorted (only appears in diagnostic test mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (only appears in diagnostic test mode).F:29Moisture sensor strip has shorted (only appears in diagnostic test mode).F:30Restricted airflow condition exists (only appears in diagnostic test mode).F:31Low voltage condition (less than 30V) detected (appears ONLY in Diagnostic Test…F:50No voltage detected at the water valve relay (appears ONLY in Diagnostic Test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure.F:73Console electronics failure.F:74Console electronics failure.F:75Console electronics failure.F:76Console electronics failure.F:77Console electronics failure.F:78Console electronics failure.L2Low line voltage (less than 30V) detected at installation.PFPower failure occurred while the dryer was running.

Service modes (7)

Adjusting Customer-Focused Drying Modes (CF1/CF2/CF3)1
Customer-Focused Drying Mode Adjustment (CF1/CF2/CF3)1
Diagnostic Test Mode1
Displaying Inlet Air Flow DiagnosticAfter all saved fault codes have been displayed in diagnostic test mode, press the Wrinkle Guard…
Displaying Line Voltage DiagnosticAfter all saved fault codes have been displayed in diagnostic test mode, press the Cycle Signal…
Manual Load Test1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Clothes…
Service Diagnostic Test Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass