Model reference

Whirlpool W10156735A

Name: Whirlpool W10156735A
Brand: Whirlpool

Dryer

1 document25 error codes4 service modes

Available documentation

Tech Sheet

Tech Sheet W10156735A16 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10156735A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dryer

AF on my Whirlpool W10156735A

M+

Restricted air flow condition exists.

From Tech Sheet W18331242, p.14:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

AFRestricted air flow condition exists.F:01Primary control failure.F:02Stuck button or user interface mismatch (appears ONLY in diagnostic test mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Exhaust thermistor is open.F:23Exhaust thermistor has shorted.F:24Inlet thermistor is open (appears ONLY in diagnostic test mode).F:25Inlet thermistor is shorted (appears ONLY in diagnostic test mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (appears ONLY in diagnostic test mode).F:29Moisture sensor strip has shorted (appears ONLY in diagnostic test mode).F:30Restricted air flow condition exists (appears ONLY in diagnostic test mode).F:31Low voltage condition (less than 30V) detected (appears ONLY in Diagnostic Test…F:50No voltage detected at the water valve relay (appears ONLY in diagnostic test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).F:78Console electronics failure (F:72 through F:78).L2Low or no line voltage detected (less than 50V) at installation.PFPower failure occurred while the dryer was running.

Service modes (4)

customer_focused_drying_mode_adjustment1
diagnostic_test_mode1
factory_default_reset1
manual_load_test1. Dryer must be in standby mode (plugged in with all indicators off, or with only the Dry…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass