mypros+
Model reference

Whirlpool W10258377

Dryer

2 documents21 error codes7 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10258377 - Rev B16 pg
    Covers this model
  • W10258377 Maytag MGDE500VW2 Dryer Tech Sheet16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10258377.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (21)

CodeMeaning
F:01Primary control failure.F:02Stuck button or user interface mismatch (appears ONLY in Diagnostic Test Mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:26Motor drive system failure.F:28Moisture sensor strip is open (appears ONLY in Diagnostic Test Mode).F:29Moisture sensor strip has shorted (appears ONLY in Diagnostic Test Mode).F:31Low voltage condition (less than 30 V) detected (appears ONLY in Diagnostic…F:50No voltage detected at the water valve relay (appears ONLY in Diagnostic Test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).F:78Console electronics failure (F:72 through F:78).L2Low line voltage (less than 30 V) detected at installation.PFPower failure occurred while the dryer was running.

Service modes (7)

  • Customer-Focused Drying Mode Adjustment (CF1/CF2/CF3)1
  • Diagnostic Test Mode1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Dry…
  • Dryness Level Adjust (CF1/CF2/CF3)1
  • Line Voltage DisplayAfter entering the Diagnostic Test Mode, waiting for the 5 second delay, and cycling through any…
  • Manual Load Test1. Dryer must be in standby mode (plugged in with all indicators off, or with only the Dry…
  • Manual Load Test (Non-Steam Models)1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Dry…
  • Manual Load Test (Steam Models)1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Dry…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass