mypros+
Model reference

Whirlpool W10678947

Dryer

1 document18 error codes6 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W1067894748 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10678947.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (18)

CodeMeaning
F1E1Indicates a CCU (Cycle Control Unit) problem.F2E1Indicates a stuck button (depressed for over 20 seconds) or UI mismatchF3E1Indicates that the outlet thermistor is open; temperature drops below 18°F…F3E2Indicates that the outlet thermistor has shorted; temperature above 250°F (<500…F3E5Indicates that the compressor and outlet thermistors are openF3E6Indicates the moisture sensor strip is openF3E7Indicates that the moisture sensor strip has shortedF3E8Indicates that the compressor sensor is openF3E9Indicates that the compressor sensor has shortedF4E1Indicates no voltage detected at the heater relayF4E3Indicates low air flow that may affect dryer performance.F4E4Indicates low L2 voltage (less than 50V) detected at the CCU.F6E1Communication between the CCU and UI has not been detected (UI to CCU…F6E2Communication between the CCU and UI has not been detected (CCU to UI…F9E1Drain system errorL2Low L2 voltage (less than 50V) detected at the CCU.LFIndicates that the lint filter has been removed from running position.PFPower failure occurred while the dryer was running.

Service modes (6)

  • Customer-Focused Dryness Level Adjustment["In standby mode (dryer plugged in but not powered up), press and hold the DRYNESS LEVEL button…
  • Install Diagnostics["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • Loads Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off).","Within 5 seconds
  • Service Diagnostic Mode["Ensure dryer is in standby mode (plugged in with all indicators off).","Select any three (3)…
  • Software Version Display["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…
  • User Interface Test["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass