mypros+
Model reference

Whirlpool W10830031

Dryer

1 document17 error codes6 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10830031 - Rev A36 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10830031.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (17)

CodeMeaning
AFLow airflow detected that may affect dryer performance.F1E1Motor relay stuck on, indicates an ACU problem.F1E3Incorrect controller installed (electric models only); ACU and/or UI part…F2E1Stuck button on User Interface (depressed for over 20 seconds); only appears in…F2E4UI Software ErrorF2E5UI Software ErrorF3E1Exhaust thermistor is open or shorted; open if temperature drops below 18°F…F3E2Moisture sensor strip is open or shorted; only appears in service diagnostic…F3E3Inlet thermistor is open or shorted; open if temperature drops below 18°F…F4E1Heater 1 failure or connector problem; no voltage detected at the heater relay.F4E2Heater 2 failure or connector problem (electric models only); no voltage…F4E3Restricted airflow detected that may affect dryer performance.F4E4L2 line voltage error (electric models only); low L2 voltage (less than 50 V)…F6E2Communication errorF6E3Communication errorL2Low L2 voltage (less than 30 V) detected at the CCU.PFPower failure occurred while the dryer was running.

Service modes (6)

  • Customer-Focused Dryness Level AdjustmentIn standby mode (dryer plugged in but not powered up), press and hold the DRYNESS button for…
  • Fault Code Display / ClearFrom Service Diagnostic Mode
  • Key Activation & Encoder TestFrom Service Diagnostic Mode, press and release the 1st button used to activate Service Diagnostic…
  • Service Diagnostic Mode1. Ensure dryer is in standby mode (plugged in with all indicators off). 2. Select any three…
  • Service Test ModeFrom Service Diagnostic Mode, press and release the 2nd button used to activate Service Diagnostic…
  • Software Version DisplayFrom Service Diagnostic Mode, press and hold the 2nd button used to activate Service Diagnostic…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass